NeuraLabel Callisto Prime Label Printer
In The Box
- Ink Set
- Power Cable
- Network Cable
- Printer
- Packaging Materials
INFORMATION
Save packaging materials with the original printer box in case printer is shipped at a later date.
UNBOX PRINTER
- Remove white handles.
- Do not cut box tape.
- Lift upper box lid from lower box.
- Remove outer packaging
- Lift printer with 2 people and set on a sturdy table.
REMOVE INTERIOR PACKAGING
- Remove blue packaging tape.
- Pull out left/right orange sled caps and blue tape.
- Pull out orange ink cap and blue tape.
- Remove screen cover.
READY PRINTER
- Install ink by pushing in until cartridge clicks into place.
- Plug in power and network cables. Turn on power switch.
- In about 2 minutes Printer Ready displays in lower left display corner
- Watch the Setup Video
Documents / Resources
 |
NeuraLabel Callisto Prime Label Printer [pdf] User Guide Callisto, Prime Label Printer, Callisto Prime Label Printer, Label Printer, Printer |
