Network Technology HM11 Bluetooth Speaker Instruction Manual

Product built-in rechargeable battery. the new battery only needs 2-3 hours for and discharge cycles. Do not make the battery fully charged, because overcharging will shorten the life of cycle of the first time to complete the charge speakers.
If you do not use, power might loss a little.

products placed in the hot or cold places, which will shorten the life of the product.

Charger care

Please use the standard 5V DC adapter to charge. Use of any other type may damage the product.
Charging according to instructions.

IMPORTANT: Please refer to the description of the user’s manual of the charge status indicator, Some speakers can not be used when charging.

Accessories

1* HM11 Bluetooth speaker

1* USB charging cable
1* audio cable

1* manual

Integrated battery charging:
This Bluetooth speaker is equipped with an integrated rechargeable lithium battery

Insert the charging cable DC 5V, connect the USB to the computer or AC /DC adapter. LED indicator light turn red means speaker is in charge.
When the speaker is fully charged, the red indicator will turn off.

Pair of HM11 Bluetooth speakers for mobile phones or other devices

Active Bluetooth speaker pairing mode. The speaker in the shutdown mode,long press the key for 3 seconds, the speaker begins to make a pairing. Boot into the paired connection —open the speaker , if the speaker was not previously connected with the phone or other Bluetooth devices it automatically enters to wait for pairing; if the speaker and other Bluetooth devices connected before, when starting up, it will automatically connect the last connection device.

Tips
Make sure the Bluetooth speaker is in the boot mode and start activating the pairing.

Turn on your phone and activate the Bluetooth function.
Search for Bluetooth devices, H8 will appear.
Connect HM11.If you need to pass the password, you can enter “0000”, then HM11 will connect to your phone to start using.

Bluetooth function usage

Volume adjust
Volume dial
Next
Play/Pause Mode
Previcus
Bluetooth indicate light
The passive unit AUX
Audio port
USB flash disk
Charging port
TF card read

Turn on/off (Pic 4), long press 4 seconds. Bluetooth indicate light(Pic 6) flicker and into bluetooth match mode, turn off long press 4 seconds too
Play/Pause: short press will alternate play and pause. Double press will change mode When receive calling, short press to answer call, double press will refuse the call Double press will call the latest calling person when speaker on normal model 2. Previous music(Pic 5) short press

Next music(Pic 3) short press
Volume adjust(Pic 1) rotate can adjust volume

AUX external audio:
AUX audio port (Pic 8)
Insert audio wire after turn on the speaker, will into AUX made automatics USB read(Pic 9): can insert USB to listen music

FCC Warning

This device complies with Part 15 of the FCC Rules .Operation is subject to the following two conditions:

This device may not cause harmful interference, and

This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help

NOTE: This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.

RF exposure
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Frequently Asked Questions (FAQ)

Q: How long does it take to fully charge the HM11 Bluetooth speaker?
A: The new battery only needs 2-3 hours for initial charge/discharge cycles. Avoid overcharging to prolong battery life.
Q: Can I use any type of charger to charge the HM11 speaker?
A: No, please use a standard 5V DC adapter for charging to prevent damage to the product.
Q: How do I pair my HM11 Bluetooth speaker with my phone?
A: Ensure the speaker is in pairing mode, activate Bluetooth on your phone, search for devices, select “HM11,” and enter “0000” if required for connection.

Documents / Resources

Network Technology HM11 Bluetooth Speaker [pdf] Instruction Manual
2BBEM-HM11, 2BBEMHM11, hm11, HM11 Bluetooth Speaker, Bluetooth Speaker, Speaker

References

User Manual

Network Technology HM11 Bluetooth Speaker

Security guidance