Nakamichi-LOGO

Nakamichi NC-A210 Universal Rear View AHD Camera

Nakamichi-NC-A210-Universal-Rear-View-AHD-Camera-PRODUCT

SPECIFICATIONS

  • Sensor Chip N1080M
  • Wide Angle 160°
  • Video Output AHD1080P
  • Video Format PAL
  • Power DC 12V
  • Waterproof IP68
  • Array Size 1920H x 1080V
  • Pixel Size 3.0um H x 3.0um V
  • Cable BMW-DC
  • parking with moving support

INSTALLATION

Please read these instructions carefully before installation and use. Installation should be performed by professional staff.

A. INSTALLATION INSTRUCTION FOR EMBEDDED/PUNCHING CAMERANakamichi-NC-A210-Universal-Rear-View-AHD-Camera-FIG (1)

  1. Before making a hole in the car, please make sure the diameter of the camera equal to the drill bit.
  2. According to the arrow indicated direction (up) to install .
  3. Insert the lead wire of the camera into the hole and then begin to install the camera.
  4. As above diagram, using two thumbs to push the camera into the car with balanced forces.

B. INSTALLATION INSTRUCTIONS FOR HANGING CAMERANakamichi-NC-A210-Universal-Rear-View-AHD-Camera-FIG (2)

  1. For easy installation, please use drill to open a screw hole at the appropriate position in the rear license plate of the car.
  2. Tighten the first screw into the screw hole with screw driver.
  3. Please adjust the camera’s position according to the actual display on the monitor.
  4. After adjustment, please use drill to open the second screw hole.
  5. After fixing the second screw, all the installation are finished.

C. LNSTALLATION INSTRUCTION FOR LICENSE PLATENakamichi-NC-A210-Universal-Rear-View-AHD-Camera-FIG (3)

  1. Take out of the license plate adjust the direction up and down.
  2. Align license plate to the installation location of the car.
  3. Tighten the screws, install the license plate frame camera.
  4. Adjust up and down angles of the camera, then fixed the screw.

D. ASSEMBLY DIAGRAM FOR EXCHANGING THE FRONT HOUSING OF PUNCHING/EMBEDDED AND HANGING CAMERA.Nakamichi-NC-A210-Universal-Rear-View-AHD-Camera-FIG (4)

  1. As above diagram shown, change the front housing of embedded / punching camera to hanging one.
  2. As above diagram shown, change the front housing of hanging camera to an embedded/punching one.

IMAGE INSTRUCTIONNakamichi-NC-A210-Universal-Rear-View-AHD-Camera-FIG (5)

WHAT’S IN THE BOX

  1. Camera xipc
  2. 6m Video Cable xIpc
  3. Ø7×10 mm Screw x3pcs
  4. User Manual xipc
  5. 3M Adhesive xipc

CONTACT

  • CONNECT WITH US ONLINE TO EXPLORE NAKAMICHI’S COMPLETE RANGE,
  • INSTRUCTIONS & SOFTWARE DOWNLOADS AND WARRANTY REGISTRATION.
  • WWW.NAKAMICHICARAUDIO.COM
  • fB nakamichi. global
  • INST: nakamichi. caraudio

Nakamichi-NC-A210-Universal-Rear-View-AHD-Camera-FIG (6)

Documents / Resources

Nakamichi NC-A210 Universal Rear View AHD Camera [pdf] User Manual
NC-A210 Universal Rear View AHD Camera, NC-A210, Universal Rear View AHD Camera, Rear View AHD Camera, View AHD Camera, AHD Camera, Camera

References

Leave a comment

Your email address will not be published. Required fields are marked *