SPCOM00000044 N-Com System
INSTRUCTIONS FOR REPLACING THE SPCOM00000044
- Remove the N-Com system from the helmet (see instruction booklet).
- Open the e-box (Fig. 1-2).
- Disconnect the antenna connector (Fig. 3).
- Place the new antenna inside the plastic box (e-box).
- Connect the new antenna.
- Only for BX4 – Position the cable in the special fixing hook (Fig. 4).
- Close the e-box (Fig. 5).
- Make sure that all fixing points are properly secured.
- Reposition the N-Com system inside the helmet (see instruction booklet).
Documents / Resources
 |
n-com SPCOM00000044 N-Com System [pdf] Instructions SPCOM00000044 N-Com System, SPCOM00000044, SPCOM00000044 N-Com |
