n-com SPCOM00000032 Right Cable User Manual

n-com SPCOM00000032 Right Cable

INSTRUCTIONS FOR REPLACING THE SPCOM00000032

1. Remove the N-Com system from the helmet (see instruction booklet).
2. Open the e-box (Fig. 1-2).
3. GENTLY remove the electronic card from its place.
4. Remove the wiring (Fig. 3).
5. Replace the wiring and position the new wiring connector in the counterpart on the electronic card.
6. Replace the electronic.
7. Close the e-box (Fig. 4-5).
8. Reposition the N-Com system inside the helmet (see instruction booklet).