GRAPHTEC CE8000 Serje Roll Feed Cutting Plotter Istruzzjonijiet
Wireless LAN Setup for the Graphtec CE8000 Series Cutter
Setting up your Wireless LAN is easy and accomplished in a few simple steps.
Jekk jogħġbok segwi l- ON-SCREEN INSTRUCTIONS:
- Agħżel Lingwa
- Agħżel Unità ta' Miżura
- Confirm Ready for Setup
- Agħżel Wireless Network
- Input Password
Input the password to your Wireless Network.
- Qabbad man-Netwerk Wireless
When the password has been accepted, it will ask if you want to Connect to the Network.
- Assign Dynamic IP Address
When connected, the screen will show the Default Static IP address with DHCP mode turned
- Switch to DHCP mode
Turn DHCP
u mbagħad ikklikkja OK
THIS STEP IS VERY IMPORTANT:
A Dynamic IP address protocol is set and your cutter will automatically reinitialize.
- Confirmation of Connection
After restarting, your cutter will show the
IKONA MINGĦAJR FILI at top right of display.
This indicates the Wireless LAN has been successfully setup and is now ready to be discovered on your Local Wireless Network.
For further information please reference
Chapter 9.2 Connecting via Wireless LAN
from the CE8000 User’s Manual.
Dokumenti / Riżorsi
 |
GRAPHTEC CE8000 Series Roll Feed Cutting Plotter [pdf] Istruzzjonijiet CE8000, CE8000 Series Roll Feed Cutting Plotter, CE8000 Series, Roll Feed Cutting Plotter, Feed Cutting Plotter, Cutting Plotter, Plotter |
