USER MANUAL

SElflE STICKTRIPOO

Selfie Stick Tripod
Mpow PA194A

Package Contents

Package Contents

Tripod Components

Tripod Components
  1. l/4″ Screw
  2. Tri pod stand
  3. Rubber sleeve
  4. Tilt locking knob
  5. Flip locks
  6. Center column locking knob
  7. Center brace
  8. Center column base

Tripod Operation

Tripod Operation
Tripod Operation

l. Rotate the center column locking knob
counterclockwise to release the center column.
Open the tripod stand and move it to the height
you want. and then rotate the locking knob
clockwise to lock the legs firmly in place.

  1. Pull out the flip lock to extend the center column to the desired height and then press down the flip lock to fot The maximum working height is 57″/l 45cm. (Retract it in the same way.)
  2. Rotate the center column locking knob counterclockwise to have the legs folded up around the center column. and then relock it. The minimum working height isl 7″/43cm.

Phone Holder Assembly

Phone Holder Assembly

Bluetooth Pairing

Bluetooth Pairing
  1. Turn on the Bluetooth remote control. The blue light flashes to show that it enters the pairing mode.
  2. Turn on the Bluetooth on your phone and search for new devices. Pair up with”AB shutter 3″ successfully and the light will go off.
  3. Turn off the remote control to shut the Bluetooth down.

Battery Replacement {Battery Model, CR2032)

Cautions

  1. Set the volume button on your phone to act as the shutter button. Use the remote control to take a photo.
  2. Please check up whether the Bluetooth connects to the previously connected device when you are having trouble pairing your phone with the remote control.
  3. Remove the camera or phone from the tripod during transport.
  4. Ensure that every lock/knob engaged is tighten and tripod securely placed before using.
  5. When the battery of remote control is running low. Bluetooth pairing may fail.
  6. Keep the selfie stick tripod from anything corrosive.

FCC Statement

Any Changes or modifications not expressly approved by the party responsible for compliance couId void the use(s authority to operate the equipment

This device complies with part 15 of the FCC Rules Operation is subject to the following t\MJ conditions


(1 ) This dEMce may not cause harmful interference. and
(2) This device must accept any interference received. including interference that may cause undesired operation.

FCC Radiation Exposure Statement,
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment

Questions about your Manual? Post in the comments!

Leave a comment

Your email address will not be published. Required fields are marked *