USER MANUAL
Selfie Stick
Mpow ISNAP X1 / PA168A
Packing
Diagram
- Fill Light
- Phone Holder
- Adjusting Knob
- l/4″ Screw for GoPro or camera
- Remote Control
- Handle
- Stable Tripod Stand
Pairing
Long press the camera key for 2s until the blue light flashes. Turn on the wireless function on your phone and select “Mpow isnap x1 ” the blue light stays on if paired successfully.
Tips: Tum off: Long press the camera key for another 3s to turn it off.
Step-1.
Loosen the knob and adjust the angle up and down. After adjusting the angle. tighren the knob and put your phone on. (Vertical or Horizontal)
Step-2.
The tripod is located in the handle slot open it outwards when in use. After unfolding the tripod, push the locking device
Step-3.
The remote control is connected to the mobile phone, and the effective distance of the remote control is up to 10 meters/33 feet
Tips
- The remote control will automatically sleep after 5-10mins if without any operation. just click the camera key to wake it up.
- The remote control will automatically off after 30mins if without any operation, and you need to press the camera key for 2 seconds to tum it on
How to Use the Fill Light?
How ID Install a camera or GoPro on the Tripod?
For camera
For GoPro
How to install a cameras or GoPro on the tripod
Step-1.
Adjust the l /4″ screw to the right position with the adjusting knob
Step-2.
Connect the l /4″ screw to the screw thread at the bottom of the camera/GoPro connector and then tighten it
Questions about your Manual? Post in the comments!
Does the handle get power from a battery that will need replaced, if so how do I recharge or replace the battery.
You can push the button (5) upwards to press it. There’s also a little arrow on the handle that shows that. Then you can simply charge the chip with a charging cable, just like the light.
Man kann den Knopf zum Drücken (5) nach oben rausschieben. Da ist auch ein kleiner Pfeil am Griff, der das zeigt. Dann kann man den Chip einfach mit einem Ladekabel aufladen, genau wie das Licht auch.
I’ve had this selfie stick for about 8 months and have only used it maybe 6 times. The blue light won’t turn on now. What is the troubleshooting process to get it to work again?
I just found mine after 6 months and couldn’t remember how to use it, so I googled and followed the directions above. First I charged both the remote and the fill flash.