Wireless Rotor Runout Kit
User Guide
Important Notes
- Turn off BlueDial (1 and 6) and BlueAngle (9) after use. It will NOT turn off automatically.
- Do NOT open the device. Opening causes permanent damage and voids the warranty.
- BlueDial transmitter & digital indicator should be both on before pairing.
BlueDial operates on two separate batteries:
1) Rechargeable built-in Li-Po battery for the Bluetooth transmitter
2) Coin SR44 or LR44 battery for the digital dial
Description
- Dial On/Off – press to turn dial on/off
- Origin Button – press to zero dial reading; this can also be done in the App
- Unit Button – select reading in inch/mm
- SPC Output – SPC data output port
- Dial Battery – insert coin battery SR44 or LR44 for digital dial
- BLE On/Off – press to turn Bluetooth transmitter on/off
- Status LED
– Bluetooth transmitter is on
– BlueDial is in charge
– BlueDial is fully charged - Micro USB Port – connect to USB cable to charge BlueDial
- On/Off Button – press to turn sensor on/off
- Micro USB Port – connect to USB cable to charge BlueAngle
- Status LED
– BlueAngle is on
– BlueAngle is in charge
– BlueAngle is fully charged
Included in the box
- BlueDial 1X
- Bluetooth Angle Sensor BlueAngle 1X
- USB Charging Cable 1X
- USB Power Adapter 1X
- User Guide 1X
Quick Start
- Turn on both digital indicator and Bluetooth transmitter of BlueDial. Turn on BlueAngle. Pair gages in the App.
- Attach BlueDial and BlueAngle to the testing shaft. Select the right angle on the Setting page. Enter the number of testing points.
- Start testing session. Rotate the shaft until all dash lines on the angle indicator become solid green lines.
- Move BlueDial to the next testing location, tap Add a plane button to start test for the next plane.
www.livetest.com.au
02 4017 0198
sales@livetest.com.au
115 Young St Carrington NSW 2294
Documents / Resources
 |
motionics BlueAngle Wireless Rotor Runout Kit [pdf] User Guide BlueAngle Wireless Rotor Runout Kit, BlueAngle, Wireless Rotor Runout Kit, Rotor Runout Kit, Runout Kit, Kit |