MONDOLUX ANGLO-EU-PLUG 2 Pin Flex and Plug
Notes
- This product complies with EN 50075:1990 (flat two-pole plugs without reconnectable, without ground contact, rated voltage 250 V AC, rated current 2.5 A)
- Do not interchange any parts of this product.
- If you have any questions regarding the installation of this product, please contact Mondolux.
Installation Steps
- Unscrew the latches on the base side of the remote controller.
- Disconnect the existing flex cable from the controller.
- Insert 2 wires into each socket on the primary side of the controller.
- Screw the latches back onto the controller.
- Installation is complete.
Installation Diagram
Manufacturer: Mondolux
- Address: 10 Plane Tree Ave, Dingley Village VIC, 3172, Australia
- Phone: +61 9551 3748
- Web: www.mondolux.com.au
- mondolux.com
Documents / Resources
 |
MONDOLUX ANGLO-EU-PLUG 2 Pin Flex and Plug [pdf] Installation Guide ANGLO-EU-PLUG 2 Pin Flex and Plug, ANGLO-EU-PLUG, 2 Pin Flex and Plug, Flex and Plug |
