Mircom logo

Mircom FleX-Net FX-4000 Network Fire Alarm Control Panel

Mircom FleX-Net FX-4000 Network Fire Alarm Control Panel

Factory Default Jumper Settings

To ensure the correct operation of the Fire Alarm Control Panel, check that the jumpers on the main board are set correctly.

Jumper Factory Default Notes
JW1 Closed Open this jumper if a PR-300 or UDACT-300 is installed
JW2 Open Do not change
JW3 Closed on pins 1 and 2

(2 leftmost pins)

Do not change
JW4 Closed Do not change
JW5 Open Close this jumper to silence the on-board buzzer
P12 Closed on pins 1 and 2

(2 rightmost pins)

Do not change
Terminal Factory Default Notes
 

TS2

There is a wire connecting positions E+ and I+

(the 2 top pins)

Do not remove

Mircom FleX-Net FX-4000 Network Fire Alarm Control Panel 1

For more details, see LT-894MP the FleX-Net™ FX-4000 Installation Manual.

firealarmresources.com

Documents / Resources

Mircom FleX-Net FX-4000 Network Fire Alarm Control Panel [pdf] User Guide
FleX-Net FX-4000 Network Fire Alarm Control Panel, FleX-Net FX-4000, Network Fire Alarm Control Panel, Fire Alarm Control Panel, Alarm Control Panel, Control Panel, Panel

References

Leave a comment

Your email address will not be published. Required fields are marked *