FleX-Net™ FX-4000 Quick Start

Factory Default Jumper Settings

To ensure the correct operation of the Fire Alarm Control Panel, check that the jumpers on the main board are set correctly.

Jumper Settings

Terminal Settings

Main Fire Alarm Board Diagram Description

The diagram illustrates the physical layout of the Main Fire Alarm Board, showing the placement of various jumpers and terminals. Key components labeled include:

• Jumpers: JW1 (Closed, with note for PR-300/UDACT-300A), JW5 (Open), JW3 (Closed on 2 leftmost pins), JW4 (Closed), P12 (Closed on 2 rightmost pins), JW2 (Open).
• Terminals: TS2 (described as having a wire connecting the 2 top pins, E+ and I+).
• Other labeled components: DISPLAY, RS232 PORT, P3, D4, P15, P19, P6, P5, MD-879 Blackfin (CM-BF537E), JH2, RESET, TS1, TS3, TS4, TS5, TS10, TS14, TS12, TS11, TS13, TS6, TS7, TS8, TS9, RS485, SYNC, COM, NO, BLNC, COM, NA, AM, NC, COM, NO, NC, SABBATH, SUD, AUX PWR, TRERTIRL, NAC, NAC, NAC+, NAC+, NAC+, NAC3, TROUBLE, SUPU, POWER EXP., CIRCUIT EXPANSION 0, CIRCUIT EXPANSION 1.

For more detailed information, please refer to the LT-894MP, the FleX-Net™ FX-4000 Installation Manual.

Document Reference: LT-6709MP Rev 0, October 2021, Page 1 of 1

Find more resources at: firealarmresources.com