Milesight UC300 Smart IoT Controller User Guide

Milesight UC300 Smart IoT Controller User Guide

Contents hide

1 Packing List

2 Hardware Introduction

3 LED Patterns

4 SIM Installation (Cellular Version)

5 Configuration Guide

6 Installation

7 Documents / Resources

7.1 References

8 Related Posts

Packing List

Hardware Introduction

LED Patterns

LED	Device Status	Description
SYS	System works	Static On
	Reset to factory default: hold the reset button inside the device for more than 10 seconds	Static On → Quickly Blinks
	Fail to acquire data from data interfaces	Slowly Blinks
	System error	Static On
ACT	Send join network requests	Blinks as Requests
	Succeed to join/register to network	Blinks Twice → Static OnBlinks Twice → Static On
	Succeed to send uplinks	Blinks Once
	Succeed to send uplink	Blinks Twice
	Receive downlinks	Blinks Twice

SIM Installation (Cellular Version)

Release the screws and cover on the antenna connector, insert the SIM card into the slot. If you want to take out the SIM card, press it to make it pop out.

Configuration Guide

Preparation:

Type-C USB cable
PC (Windows 10 is recommended)

ToolBox Software: it can be downloaded from Milesight IoT website.

Steps:

Connect the device to computer via type-C port and open the ToolBox, select serial port as USB port and type as “General”, then type the password to log in ToolBox and configure the device. (Default login password: 123456)

Installation

Wall Mounting

Fix the wall mounting bracket to the device with 2 screws.
Drill 4 holes on the wall according to the wall mounting bracket, then fix the wall plugs into the wall.