Midea Cube Pint Dehumidifier
Specifications
| Feature | Details |
|---|---|
| Usage | Indoor residential applications only |
| Temperature Range | Above 41°F (5°C) |
| Air Space | 8″ on all sides, 16″ for air outlet |
INSTALLATION INSTRUCTIONS
Positioning the Unit
The dehumidifier should be placed in the area where dehumidification is desired most. Adjacent rooms in which dehumidification is also desired should allow adequate airflow in and out of the space containing the dehumidifier.
- Do not use outdoors.
- This dehumidifier is intended for indoor residential applications only. This dehumidifier should not be used for commercial or industrial applications.
- Place the dehumidifier on a smooth, level floor strong enough to support the unit with a full bucket of water.
- Allow at least 8″ of air space on all sides of the unit for air circulation (at least 16″ for air outlet).
- Place the unit in an area where the temperature will not fall below41°fF (5 °c). The coils can become covered with frost at lower temperatures, which may reduce performance.
- Place the unit away from any clothes dryer, heater or radiator.
- Close all doors, windows, and other openings to the outdoors in the room.
Optional Caster Installation
To install the casters
- Remove the Dehumidifier from the bucket.
- Slide each caster into the slot on the bucket’s bottom corner as shown below.
- Place the retaining block into the slot to hold the caster in place.
- Repeat this for each corner of the bucket until all 4 casters are installed.
To remove the casters
- Use a flathead screwdriver to actuate the tab on the retaining block.
- Remove the retaining block and slide the casters out of the slot on the bucket.
NOTICE
With the casters attached, do not move the unit and bucket assembly while there is water in the bucket. Before rolling the bucket, remove the unit.
Additional Setup and Usage Information
Scan this QR code with your mobile device to see a playlist of helpful videos about your new Cube Dehumidifier.
FAQs
-
Can I use the dehumidifier outdoors?
No, this dehumidifier is intended for indoor residential applications only.
What is the minimum temperature for operation?
The unit should be placed in an area where the temperature will not fall below 41°F (5°C)
How do I install the casters?
Remove the dehumidifier from the bucket, slide each caster into the slot, and place the retaining block to hold it in place.
Can I move the unit with water in the bucket?
No, you should remove the unit from the bucket before moving it if there is water inside
Documents / Resources
 |
Midea Cube Pint Dehumidifier [pdf] Installation Guide Cube Pint Dehumidifier, Pint Dehumidifier, Dehumidifier |