FUTO35S 2 In 1 LED Strip Controller

Product Information

Specifications:

Product Name: MiBoxer – 2 in 1 LED Strip Controller

Contact Number: (682)-259-4717
Website: www.supertechlights.com

Product Usage Instructions:

1. Powering On/Off:

To power on the LED strip controller, press the power button
located on the device. To power off, press and hold the same button
for a few seconds.

2. Mode Selection:

Use the mode selection buttons to choose different lighting
modes for your LED strips. Navigate through the options until you
find the desired mode.

3. Brightness Adjustment:

Adjust the brightness of the LED strips by using the brightness
control buttons. Increase or decrease the brightness levels as
needed.

4. Color Changing:

If your LED strips support color changing, use the color
adjustment buttons to cycle through different colors or set a
specific color for your lighting setup.

5. Remote Control:

If your LED strip controller comes with a remote control, make
sure to point it towards the controller when making adjustments for
optimal signal reception.

Frequently Asked Questions (FAQ):

Q: How do I reset the LED strip controller?

A: To reset the controller, locate the reset button on the
device and press it using a small pointed object like a paperclip.
Hold the button for a few seconds until the controller resets.

Q: Can I connect multiple LED strips to this controller?

A: Yes, you can typically connect multiple LED strips to the
MiBoxer 2 in 1 LED Strip Controller as long as the total power
consumption of the strips does not exceed the controller’s
capacity. Refer to the user manual for specific guidelines on
connecting multiple strips.

Q: How do I update the firmware of the controller?

A: Firmware updates, if available, can usually be done by
downloading the latest firmware version from the manufacturer’s
website and following the provided instructions for updating the
controller.

View Fullscreen

MiBoxer – 2 in 1 LED Strip Controller

(682)- 259- 4717
www.supertechlights.com