E012024-MMF 8 Zone RGB plus CCT Remote Controller
Specifications:
- Model: E012024-MMF
- FCC Compliance: Part 15
- RF Exposure: General requirements met
Product Information:
This device (Model: E012024-MMF) complies with part 15 of the
FCC Rules. It meets the general RF exposure requirement and can be
used in portable exposure without restriction.
Users are advised that any changes or modifications not approved
by the responsible party for compliance may void the user’s
authority to operate the equipment.
Product Usage Instructions:
1. FCC Compliance:
Ensure that the device is operated in compliance with Part 15 of
the FCC Rules. The device must not cause harmful interference and
must accept any interference received.
2. RF Exposure:
As the device meets general RF exposure requirements, users can
use it in portable exposure situations without restrictions.
However, it is recommended to maintain a safe distance from the
device during operation.
3. Modifications:
Avoid making any changes or modifications to the device that are
not expressly approved by the responsible party for compliance.
Unauthorized modifications may impact the device’s performance and
FCC compliance.
FAQ:
Q: Can I modify the device without approval?
A: No, any changes or modifications not approved by the
responsible party for compliance could void your authority to
operate the equipment.
E012024-MMF
E012024-MMF
FCC Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: –Reorient or relocate the receiving antenna. –Increase the separation between the equipment and receiver. –Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. –Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The device has evaluated to meet general RF exposure requirement. The device can be used be in portable exposure without restriction.
Documents / Resources
 |
MiBOXER E012024-MMF 8 Zone RGB plus CCT Remote Controller [pdf] User Manual 2BPTTE012024-MMF, E012024-MMF 8 Zone RGB plus CCT Remote Controller, E012024-MMF, 8 Zone RGB plus CCT Remote Controller, RGB plus CCT Remote Controller, CCT Remote Controller, Remote Controller, Controller |