FLOOR LAMP
Save these instructions
IMPORTANT SAFETY INSTRUCTIONS:
- These instructions are provided for your safety.
Please read carefully and completely before beginning the assembly and installation of this lighting fixture. - This lighting fixture is intended for indoor use only.
- Always place lighting fixture on a solid, level surface.
- For use with E26 (medium) base light bulbs only.
- To avoid the risk of fire, do not exceed the maximum wattage of 100W incandescent bulb
, or 9W LED bulb 
, or 23W fluorescent (CFL) bulb 
, or 9W self-ballasted LED bulb 
. (Bulbs not included) - This lighting fixture has a polarized plug (one prong is wider than the other) as a safety feature to reduce the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted. Do not alter the plug. Do not attempt to bypass this safety feature.
WARNINGS:
- To reduce the risk of fire, electrical shock, or personal injury: always turn off and unplug this lighting fixture and allow it to cool before attempting to replace the light bulb.
- Do not touch light bulb while fixture is turned on.
- Keep flammable materials away from this lighting fixture.
- Never look directly at a lit bulb.
CARE INSTRUCTIONS:
- Unplug lamp before cleaning.
- Wipe clean with a soft, dry cloth or static duster.
- Always avoid the use of harsh chemicals or abrasive cleaners as they may cause damage to the fixture’s finish
PRE-ASSEMBLY:
Carefully remove all parts and hardware from carton, along with any protective plastic packaging. The lampshade may be covered with a plastic film that should be removed before use.
Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or hardware.
* Part A (Finial) may come pre-installed to Part C (Harp).
Unscrew Part A before installing Part B (Lampshade), then reinstall Part A to secure.
Carefully pull the power cord out from the Base (J) to remove slack.
PARTS INCLUDED:
(A*) Finial
(B) Lampshade
(C) Harp
(D) On/Off Switch
(E) Top Post
(F) Middle Post
(G) Bottom Post
(H) Base Collar
(J) Base
For use with light bulbs with a E26 (medium) base.
DO NOT EXCEED THE SPECIFIED WATTAGE.
BEGIN ASSEMBLY AT THE TOP AND WORK DOWN.
BE CAREFUL NOT TO STRIP THREADS.
INSTALL LAMPSHADE LAST.
Documents / Resources
 |
Meyer Cross FL1570 Floor Lamp [pdf] Instructions FL1570 Floor Lamp, FL1570, Floor Lamp, Lamp |