MEAN WELL SE-1000 series 1000W Single Output Power Supply
FAQs
Q: What should I do if the power supply fails to turn on?
A: If the power supply fails to turn on, check the =following:
- Ensure the AC input is connected properly and providing the correct voltage.
- Verify that the power supply is securely mounted and all connections are tight.
- If applicable, check for any blown fuses or tripped circuit breakers.
- Contact customer support if the issue persists.
Features
- AC input active surge current limiting
- AC input range selected by switch
- Protections: Short circuit / Overload / Over voltage Over temperature
- Forced air cooling by built-in DC ball bearing fan
- High power density 7.3w/inch®
- With DC_OK signal output
- Built-in remote ON-OFF control
- Built-in remote sense function
- UL / CUL approved
- Low cost
- 2 years warranty
GTIN CODE
SPECIFICATION
Product Liability Disclaimer: For detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx.
Mechanical Specification
TB1:AC input terminal
Pin No. | Assignment |
1 | AC/L |
2 | AC/N |
3 | FG |
TB2:110/220V Change
Pin No. | 110V | 220V |
1 | Short | Open |
2 |
Control Pin (CN3) : JST B6B-XH or equivalent
Pin No. | Assignment | Pin No. | Assignment | Mating Housing | Terminal |
1 | DC_OK Signal | 4 | +S | JST XHP
or equivalent |
JST SXH-001T
or equivalent |
2 | DC_OK GND | 5 | RC- | ||
3 | -S | 6 | RC+ |
Block Diagram
Derating Curve
Static CharacteristicsMechanical Specification
- DC_OK Signal
- DC_OK Signal is the voltage difference between “DC_OK” and “G” pin output
- DC_OK Signal is a TTL-level signal
- PSU turn on: 3.3 ~ 5.6V
- PSU turn off: 0 ~ 1V
Remote Sensing
Remote Control
Between RC+ and RC- | Output |
SW OFF(0 ~ 0.8V) | ON |
SW ON(4 ~ 10V) | OFF |
Downloaded from Arrow.com.
Documents / Resources
![]() |
MEAN WELL SE-1000 series 1000W Single Output Power Supply [pdf] Owner's Manual SE-1000 series 1000W Single Output Power Supply, SE-1000 series, 1000W Single Output Power Supply, Output Power Supply, Power Supply, Supply |