MEAN WELL GC330 Series 330W Single Output Battery Charger
Features
- Charger for lead-acid batteries
- (flooded,Gel and AGM) and Li-ion batteries (lithium iron and lithium manganese) (Note. 1)
- 2 stage charging characteristic
- Universal AC input/ Full range
- Built-in active PFC function, PF>0.95
- 3 pole AC inlet IEC320-C14
- Class I power (with earth pin)
- Protections: Short circuit / Over voltage/ Over temperature
- Fanless design, cooling by free air convection
- Fully enclosed plastic case
- No load power consumption<1W
- 2 color LED indicator for charging status
- Approvals: UL/CUL/TUV/ EAC/ CB/FCC /CE/UKCA
- 2 years warranty
GTIN CODE
MW Search: https://www.meanwell.com/serviceGTIN.aspx
SPECIFICATION
| ORDER NO. | GC330A36-C4P | GC330A48-C4P | |
|
OUTPUT |
SAFETY MODEL NO. | GC330A36 | GC330A48 |
| DC VOLTAGE (Typ.) | 40.8V | 54.4V | |
| RECOMMENDED BATTERY CAPACITY Note.3 | 20 ~ 65Ah | 20 ~ 65Ah | |
| PEAK CURRENT(Typ.) Note 5 | 8A | 6A | |
| CONTINUOUS OUTPUT
CURRENT (Typ.) Note 6 |
6.4A | 4.8A | |
| OUTPUT POWER RANGE | 261.1 ~ 326.4W | 261.1 ~ 326.4W | |
| LED INDICATOR | Charging(CC) : RED Floating charging(CV) : GREEN | ||
|
INPUT |
VOLTAGE RANGE Note.4 | 90 ~ 264VAC 127 ~ 370VDC | |
| FREQUENCY RANGE | 47 ~ 63Hz | ||
| POWER FACTOR (Typ.) | PF>0.95 / 230VAC PF>0.98 / 115VAC at full load | ||
| EFFICIENCY (Typ.) | 93.5% | 93.5% | |
| AC CURRENT (Typ.) | 4A / 115VAC 2A / 230VAC | ||
| INRUSH CURRENT (max.) | 120A / 230VAC | ||
| LEAKAGE CURRENT(max.) | 1.5mA / 240VAC | ||
|
PROTECTION |
SHORT CIRCUIT | Protection type : Hiccup mode, recovers automatically after fault condition is removed | |
| OVER VOLTAGE | 105 ~ 135% rated output voltage | ||
| Protection type : Shut down o/p voltage, re-power on to recover | |||
| OVER TEMPERATURE | 100℃±10℃(RTH2) | ||
| Protection type : Shut down o/p voltage, re-power on to recover | |||
|
ENVIRONMENT |
WORKING TEMP. | -30 ~ +60℃ (Refer to “Derating Curve”) | |
| WORKING HUMIDITY | 20% ~ 90% RH non-condensing | ||
| STORAGE TEMP., HUMIDITY | -40 ~ +85℃, 10 ~ 95% RH | ||
| TEMP. COEFFICIENT | ±0.03% / ℃ (0~40℃) | ||
| VIBRATION | 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes | ||
|
SAFETY & EMC (Note. 7) |
SAFETY STANDARDS | UL62368-1, TUV BS EN/EN62368-1, EAC TP TC 004 approved | |
| WITHSTAND VOLTAGE | I/P-O/P: 3KVAC | ||
| ISOLATION RESISTANCE | I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH | ||
| EMC EMISSION | Compliance to BS EN/EN55032 class B, BS EN/EN61000-3-2,3, FCC PART 15 / CISPR22 class B, CAN ICES-3(B)-NMB-(B), EAC TP TC 020 | ||
| EMC IMMUNITY | Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11, light industry level, EAC TP TC 020 | ||
|
OTHERS |
MTBF | 1624.8K hrs min. Telcordia SR-332 (Bellcore) ; 209.5K hrs min. MIL-HDBK-217F (25℃) | |
| DIMENSION | 220*95*46mm (L*W*H) | ||
| PACKING | 1.25Kg; 12pcs/16Kg/1.09CUFT | ||
| CONNECTOR | PLUG | See page 2 | |
| CABLE | See page 2 | ||
| NOTE | 1. Modification for charger specification may be required for different battery specification. Please contact battery vendor and MEAN WELL for details. 2. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25C of ambient temperature. 3. This is MeanWell’s suggested range, please consult your battery manufacturer for their suggestions about maximum charging currentlimitation. 4. Derating may be needed under low input voltage. Please check the derating curve for more details. Test condition is at 25C the charging current vary with the ambient and components temperature. The lower temperature, the higher charging current. 5. Maximum charging current ill be in the range of 85-110% rated output Current. 7. The power supply is considered as an independent unit, but the final equipment still need to re-confirm that whole system complies with the EMC directives. 8. The ambient temperature derating of 3.5 C/1000m with fanless models and of 5 C1000m with fan models for operating altitude higher than 2000m(650oft). xProduct Liability Disclaimer For detailed information., please refer to https://www.meanvwell.com/serviceDisclaimer.aspx |
||
Mechanical Specification
Plug Assignment
Standard male plug(power supply side): AMP 1-480702-0 equivalent
Female plug(customer side, not provide with the power supply):AMP 1-480703-0 equivalent
Charging Curve
Suitable for lead-acid batteries (flooded, Gel and AGM) and Li-ion batteries (lithium iron and lithium manganese)
| GC330A36 | 20-65Ah |
| GC330A48 | 20-65Ah |
Derating Curve
Static Characteristics
Documents / Resources
 |
MEAN WELL GC330 Series 330W Single Output Battery Charger [pdf] Owner's Manual GC330A36-C4P, GC330A48-C4P, GC330 Series 330W Single Output Battery Charger, GC330 Series, 330W Single Output Battery Charger, Single Output Battery Charger, Output Battery Charger, Battery Charger, Charger |
