MEAN WELL GC30B Series 16.8 30W Power Adaptor with Charging Function Owner’s Manual
Features
- Charger for lead-acid batteries (flooded, Gel and AGM) and li-ion batteries (lithium iron and lithium manganese) (Note.1)
- Universal AC input / Full range
- 2 pole AC Inlet IEC320-C8
- Class II power (without earth pin)
- No load power consumption <1.0W
- Constant current and voltage(CC,CV mode)
- Suitable for continue load For high surge current equipment
- Protections: Short circuit/Overload/Over voltage/Over temp.
- 2 colors LED indicate for charging status
- Fully enclosed plastic case
- High reliability
- Approvals: UL/CUL/TUV/EAC/CB/FCC/CE/UKCA
- 2 years warranty
GTIN CODE
MW Search: https://www.meanwell.com/serviceGTIN.aspx
ORDER NO. | GC30 B-OP 1J | GC 30B-1P 1J | GC3013-11P 1J | GC 30B-2P 1J | GC30 B4 P 1J | GC 30B-5P 1J | GC 30 B-6P1J | |
OUTPUT | SAFETY MODEL NO. | GC30B-0 | GC30B-1 | GC30B-11 | GC30B-2 | GC30B-4 | GC30B-5 | GC30B-6 |
DC VOLTAGE SET AT Note.3 | 4.2V | 5.6V | 7.2V | 8.4V | 14.3V | 16.8V | 28.6V | |
RATED CURRENT | 4A | 3.99A | 3A | 3A | 2.09A | 1.6A | 1.04A | |
CURRENT RANGE | 0-4A | 0 – 3.99A | 0 – 3A | 0 -3A | 0 – 2.09A | 0 – 1.6A | 0 – 1.04A | |
RATED POWER | 16.8W | 22.38W | 21.6W | 25.2W | 30W | 27W | 30W | |
RIPPLE & NOISE (max.) Note!’ | 50mVp-p | 50mVp-p | 80mVp-p | 80mVp-p | 100mVp-p | 100mVp-p | 150mVp-p | |
CHARGING VOLTAGE RANGE HMS | 3.6 – 4.4V | 5 – 5.8V | 6.5 – 7.5V | 7.7 – 8.6V | 13.5 – 14.5V | 16 – 17V | 27.1 – 28.8V | |
LINE REGULATION Note.6 | ±1.0% | ±0.5% | ±0.5% | ±0.5% | ±0.5% | ±0.5% | ±0.5% | |
LED INDICATOR | Green LED ON < 100mA, Red LED ON > 250mA | |||||||
SETUP, RISE, HOLD UP TIME | 200ms, 50ms, 16ms at full load | |||||||
INPUT | VOLTAGE RANGE | 90 – 264VAC 127 – 370VDC | ||||||
FREQUENCY RANGE | 47 – 63Hz | |||||||
EFFICIENCY (Typ.) | 55% | 170% | 174% | i 76% | 178% | 178% | 180% | |
AC CURRENT | 0.7A/100VAC; 0.35A/230VAC | |||||||
INRUSH CURRENT (max.) | 40A/230VAC | |||||||
LEAKAGE CURRENT(max.) | 0.25mA/240VAC | |||||||
PROTECTION | OVERLOAD | 90 -110% Constant current mode and over 300% pulsing mode | ||||||
Protection type : Constant current limiting, recovers automatically after fault condition is removed | ||||||||
OVER VOLTAGE | 110 -135% rated output voltage | |||||||
Protection type : Clamp by zener diode | ||||||||
OVER TEMPERATURE | IC1_Tj > 130 C | |||||||
Protection type : Shut down o/p voltage, recovers automatically after temperature goes down | ||||||||
ENVIRONMENT | WORKING TEMP. | 0 – +50 C (Refer to output load derating curve) | ||||||
WORKING HUMIDITY | 20% – 90% RH non-condensing | |||||||
STORAGE TEMP., HUMIDITY | -20-+85 C, 10 – 95% RH | |||||||
TEMP. COEFFICIENT | ±0.03% / C (0 – 50 C ) | |||||||
VIBRATION | 10 – 500Hz, 2G 10min itcycle, period for 60min. each along X, Y. Z axes | |||||||
SAFETY & EMC | SAFETY STANDARDS | UL62368-1, CSA22.2, BS EN/EN62368-1, EAC TP TC 004 approved | ||||||
WITHSTAND VOLTAGE | I/P-0/P:3KVAC | |||||||
ISOLATION RESISTANCE | I/P-0/P:100M Ohms / 500VDC 125 C/ 70% RH | |||||||
EMC EMISSION | Compliance to BS EN/EN55014-1 class B, FCC part 15 Class B, EAC TP TC 020 | |||||||
EMC IMMUNITY | Compliance to BS EN/EN610004-2,3,4,5,6,11, light industry level, criteria A, EAC TP TC 020 | |||||||
OTHERS | DIMENSION | 108’67’36mm (12WH) | ||||||
PACKING | 309g; 54pcs / 19kg / CARTON | |||||||
CONNECTOR | PLUG | Standard type P1J: 2.10 ‘ 5.50 ‘I 1Imm, tuning fork type center positive for stock ; Other type available by customer requested | ||||||
CABLE | Standard type 18Awg UL1185 6ft and 4ft for 4.2V-8.4V output only for stock ; Other type available by customer requested | |||||||
NOTE | 1.Modification for charger specification may be required for different battery specification. Please contact battery vendor and MEAN WELL for details.2All parameters are specified at 230VAC input, rated load, 25C 70% RH ambient 3.DC voltage: The output voltage set at point measure by plug terminal & 0% load. 4.Ripple & noise are measured at 20MHz by using a 12′ twisted pair terminated with a 0.1 uf & 47uf capacitor.5.Output charging voltage range is measured from 0% to 100% rated load. 6.Line regulation is measured from low line to high line at rated load.iE Product Liability Disclaimer : For detailed information, please refer to https./Awiw.meanwell.com/serviceDisclaimecaspx |
Mechanical Specification
Charging Curve
Suitable for lead-acid batteries (flooded,Gel and AGM) and Li-ion batteries (lithium iron and lithium manganese)
LED Display
LED Status | Load Condition |
Red | Charging |
Green | Float Charging |
Plug Assignment
Standard plug: P1J (option)
P1J | |
P/N | OUTPUT |
CENTER | + |
Derating Curve
Static Characteristics
Documents / Resources
![]() |
MEAN WELL GC30B Series 16.8 30W Power Adaptor with Charging Function [pdf] Owner's Manual GC30B Series 16.8 30W Power Adaptor with Charging Function, GC30B Series, 16.8 30W Power Adaptor with Charging Function, Adaptor with Charging Function, Charging Function |