Printable Ring Sizer
For optimal accuracy, please print this PDF at 100% scale.
- Carefully cut out the paper ring sizer below.
- Cut along slit (just width of line) to make a slit.
- Slip the pointed end through the slit and place around your finger.
- Pull the pointed end so it slides to a snug fit.
Tip: Do not wrap the paper too tight. Aim for a comfortable, snug fit.
Alternatively, you may use a small piece of string, thread or ribbon.
Option 1: If you don’t have a ring 
Option 2: If you do have a ring
- Print the chart of ring size circles on the right.
- Find a ring you or your loved one currently wears (if shopping for someone else, make sure they wear that ring on the finger you are shopping for).
- Place the ring on top of each circle until you find a perfect match.
- The match should perfectly fit the inside of the ring.
Pro tips:
- For bands with a thicker width (~4-6mm), we recommend adjusting the size to a half size up.
- Measure in a warm, comfortable environment: room temperature is ideal as measuring when your fingers are cold or too hot can cause swelling or shrinkage.
- Your dominant hand’s fingers might be slightly larger, so make sure to size the finger on the hand where you will be wearing the ring.
- The ring should fit snugly but still be able to slide over your knuckle without much difficulty.
If the width of a credit card matches this outline, your print scale is correct.
Documents / Resources
 |
MARROW Printable Ring Sizer [pdf] Instruction Manual DAGKYrzJ6cs, BAFPD70V5pc, Printable Ring Sizer, Ring Sizer, Sizer |