PRO Vibe EVO Handlebar

Parts List

Tools shown: 4mm Allen key, T25 Torx key, PRTL0080 tool.

Brake/Shift Cable Routing

This section details the routing of brake and shift cables through the PRO Vibe EVO Handlebar.

Diagram A shows the overall routing path with points labeled A, B, C, D, E.

Step A1: Route cables through the handlebar. The diagram shows cables (labeled 1 and 2) being fed through designated channels.

Step A2: Secure cables using the provided cable port cover (Item 11). A small clip or cover is shown being attached.

Step B: Route cables from the brake levers towards the stem. The diagram shows cables (labeled 1 and 2) exiting the handlebar near the stem clamp area.

Step C: Continue routing cables. The diagram shows cables (labeled 1, 2, 3) being guided through internal channels or ports.

Step D: Final cable connection. The diagram shows cables (labeled D) being connected to a junction box or derailleur, with a note indicating 'EW-RS910*' is not included.

Note: EW-SD50 cables are used.

Installation and Assembly

Follow these steps for proper installation and adjustment of the PRO Vibe EVO Handlebar.

Step 1: Top Cap Installation

1. Insert the steerer bolt (Item 5) into the top cap (Item 4).

2. Place the top cap assembly onto the steerer tube.

Diagram shows inserting a bolt into a cap and placing it on a steerer tube.

Step 2: Stem Clamp and Angle Adjustment

1. Attach the stem to the steerer tube using the stem clamp bolts (Item 10) and appropriate shims (Item 7 or 8) if needed. The diagram shows bolts (A) and clamps (B) being used with angle indicators (+2°, 0°, -2°).

2. Adjust the handlebar angle using the shims (Item 7 or 8). The diagram shows shims being inserted between the stem and handlebar clamp, with measurements for angle adjustment (e.g., 28.6 - 31.8mm).

Diagram shows angle adjustment options (+2°, 0°, -2°) and a close-up of shim placement with a 1-3mm gap indication.

Step 3: Securing the Handlebar

1. Use a 4mm Allen key to tighten the steerer bolt (Item 5) to a maximum of 8 Nm.

2. Attach the bolt caps (Item 6) over the bolts.

3. Use a T25 Torx key to tighten the stem clamp bolts (Item 10) to a maximum of 5 Nm.

Diagram shows tightening bolts with 4mm and T25 keys, with torque specifications.

Step 4, 5, 6: Final Brake Lever/Shifter Attachment

These steps illustrate the final attachment and positioning of brake levers or shifters onto the handlebar grips.

Diagrams show the process of sliding and securing brake levers/shifters onto the handlebar grips.

Support

If you encounter issues or have questions, it is recommended to contact your local dealer.

Diagram shows a confused person thinking '[Question Mark]', then contacting a dealer via phone, and the dealer responding positively.

For more information, visit: WWW.PRO-BIKEGEAR.COM

PRO logo: 'PRO' in large white letters inside a black circle with 'POWERS YOUR PERFORMANCE' text below.