SEEMEE 150 USER MANUAL

ACCESSORY/STRUCTURE

SEEMEE 150

Micro USB Cable

HOW TO INSTALL

Scheme 1:

1. Attach the mount to the seat post.

2. Slide the light onto the mount.

3. Secure the light.

4. Final installation view.

Scheme 2:

1. Attach the mount to the saddle rails.

2. Slide the light onto the mount.

3. Secure the light.

4. Final installation view.

CHARGING/POWER INDICATOR

When the light is off, click the switch to activate the battery indicator for 3 seconds.

CHARGING

Charging: Light flashes red.

Fully charge: Light is constantly green for 3 minutes.

POWER INDICATOR

• 0% - 10%: Light flashes red.
• 11% - 20%: Light is constantly red.
• 21% - 100%: Light is constantly green.

OPERATION INSTRUCTIONS

When the brake sensor is on, the taillight enters sleep mode after 5 minutes of inactivity and automatically activates on any vibrations.

When the brake sensor detects braking, the taillight illuminates at maximum output.

TURN THE BRAKE FUNCTION ON:

When the light is off, press and hold the switch for 3 seconds until the light illuminates constantly at the highest output.

TURN THE BRAKE FUNCTION OFF:

When the light is off, press and hold the switch for 3 seconds until the light flashes quickly at the highest output.

ON/OFF:

Press and hold the switch to turn the light on/off. The default output is the last mode used when the light was turned off.

CHANGE MODE:

When the light is on, single-click the switch to cycle through modes: Low, High, Flash, Group Ride, Smart, Low...

MEMORY FUNCTION:

The mode memory feature automatically saves the last selected brightness level.

LOW POWER MODE:

When the remaining battery power is low, the switch starts flashing, and the lighting mode changes to ECO mode. The brake function is disabled during this period.

OUTPUT/RUNTIME

WARNING

All performance measurements are in accordance with ANSI/NEMA FL1-2009 Standard. The tests are performed indoors under a room temperature of 25 degrees Celsius with 25 KM/H wind conditions. The runtime may vary depending on the external temperature and ventilation conditions, and these biases may affect the results of testing.

The stated runtime of each mode excludes the brake function. When the brake function is on, the runtime will vary depending on the frequency of braking.

Do not expose the light to liquids or immerse it in water.

Do not look directly into the light source.

Contact Information

Tel: (+86) 755-295 53669

Fax: (+86) 755-275 89777

E-mail: support@magicshine.com (for orders from Magicshine.com online store)

E-mail: service@magicshine.com (for orders from other sales channels)