Dreo Tower Fan - User Manual

Looking for help?

Contact Dreo for expert support:

• Email: support@dreo.com
• Phone: (888) 290-1688 (Mon - Fri, 9:00 am - 5:00 pm PST/PDT)
• Website: www.dreo.com

Thanks for Choosing Dreo!

Your support means the world to us. We hope you enjoy our product as much as we did creating it.

Extend Your Warranty for Free

Scan or visit dreo.com/warranty to extend your warranty for free by registering your product. If you have any product issues, Dreo is always ready to help.

Follow Us to Discover More

Find Dreo on social media to stay connected and find new inspiration.

Join the Dreo community on Facebook: facebook.com/groups/dreohome

Social Media Handles: f @Dreo

Contents

1. Important Safety Instructions (Pages 1-2)
2. Assembling Your Tower Fan (Pages 3-5)
3. Knowing Your Tower Fan (Pages 6-7)
4. Using Your Tower Fan (Pages 8-10)
5. Cleaning and Maintenance (Pages 11-13)
6. Troubleshooting (Page 14)
7. Dreo Customer Care (Page 15)

Important Safety Instructions

General Safety

• Children shall not play with the appliance. Cleaning and maintenance shall not be performed by children without supervision.
• Use the appliance as described in the user manual only. Any other use not recommended may cause fire, electrical shock, or personal injury.
• This appliance can be used by children aged 8 years and above, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use in a safe way and understand the hazards involved.

Operation Safety

• Place the appliance on a flat, dry surface before use.
• Do not immerse in water or any other liquids.
• Do not use the appliance until the base is installed.
• Do not insert fingers, pencils, or other objects into the grilles while in operation.
• Do not dismantle, repair, or modify. All servicing should be performed by qualified personnel.

Electricity Safety

• Ensure the voltage of your electricity supply matches the appliance's indicated voltage.
• Always unplug before cleaning or leaving the appliance unused for a long period. Keep hands dry when plugging/unplugging.
• Do not operate any fan with a damaged cord or plug. Discard or return to an authorized service facility for examination and/or repair.
• Do not run the cord under carpeting. Do not cover the cord with rugs or runners. Do not route the cord under furniture or appliances. Arrange the cord away from traffic areas where it may be tripped over.
• WARNING: To reduce the risk of fire or electric shock, do not use this tower fan with any solid-state speed control device.
• This appliance employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per user servicing instructions and check the appliance. If the replacement fuse blows, a short-circuit may be present and the appliance should be discarded or returned to an authorized service facility.
• This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.

For Household Use Only

Read and save these instructions.

Assembling Your Tower Fan

Assembly Instructions

When using the appliance for the first time, remove the wraps and attach the parts by following the steps below:

1. Keep two base halves in a crossed position, then insert pegs on one half onto the slots on the other half.
2. Press down on edges to click two base halves together.
3. Run the cord through the center hole.
4. Fit the base onto the bottom of the fan by aligning the arrows on the underside.
5. Rotate the base clockwise to lock in place.
6. Thread the cord through the cord keepers before putting the fan upright.

CAUTION

• Do not operate the tower fan if the base has not been installed.
• Make sure to thread the cord through all rear cord keepers.

Package Contents

• Control Panel
• LED Display
• Air Outlet
• Base
• Power & Plug
• User Manual
• Quick Start Guide
• Remote Control (Battery Included)
• Carry Handle
• Remote Holder
• Air Inlet

Knowing Your Tower Fan

Control Panel

• Mode Button: Switch between Normal, Natural, Sleep, Auto Mode.
• Fan Speed Button: Adjust airflow volume (1-4 levels).
• Power Button: Turn power on/off.
• Timer Button: Select to set a timer (0-8h).
• Oscillation Button: Adjust airflow direction.

LED Display

Displays Fan Speed/Timer Hour.

Modes: Normal Mode, Natural Mode, Sleep Mode, Auto Mode.

Functions: Mute, Oscillation, Timer.

NOTE: Display will turn off after 1 minute (after 5 seconds in sleep mode). Wake up the display with any button. Display will not turn off when the auto on timer is enabled.

Getting the Most out of Your Tower Fan

1. It's not an air conditioner.
2. Remove any tall obstacles that might block the airflow from the fan.
3. Combine with your AC unit to get cooler air throughout the room.
4. Position the tower fan closer to you to get more direct airflow.
5. Place a bucket of ice in front of the fan for an extra cooling boost.

Using Your Tower Fan

General Operations

1. Touch [power button] to turn on, and [mode button] to choose a working mode.
2. Touch [fan speed button] to adjust the airflow volume.
3. Touch [oscillation button] to change the airflow direction.
4. Touch [timer button] to set a timer.
5. Touch [power button] to turn off the tower fan.

Working Modes

• Sleep Mode (Mute Auto On): Fan speed decreases every 30 minutes. Speed decreases by two levels at most and will remain constant if at level 1.
• Auto Mode: Fan speed adapts to the ambient temperature.
• Normal Mode: Fan runs at the constant speed.
• Natural Mode: Fan runs at alternating speeds.

Additional Features

• Timer: When the fan is ON/OFF, touch the timer button repeatedly to set a timer from 1 to 8 hours. When the timer ends, the fan will stop/start running automatically. To cancel, set the time to 0 hour. Note: When the auto off timer is enabled, display will return to fan speed after 3 seconds.
• Mute: Method 1: Short press the mute button [mute icon] on the remote control to turn on/off button sounds. Method 2: Long press the mode button on the control panel to turn on/off button sounds.
• Memory: If the fan is turned OFF or disconnected from power, it will operate under the previous settings (except the timer setting) when it is turned ON again.

Remote Control

Features include: Power Indicator, Decrease Fan Speed [-], Mode, Oscillation, Power [+], Increase Fan Speed, Mute, Timer.

Cleaning and Maintenance

Battery Replacement

1. Press the locking button to pop out the battery holder.
2. Replace with the same battery type (CR2025 3V) with the (+) side facing up.
3. Push in the holder until securely locked into place.

Note: If the indicator on the remote control doesn't turn on any more, please consider replacing the battery.

WARNING: Chemical Burn Hazard. Keep batteries away from children.

This product contains a lithium button/coin cell battery. If swallowed or enters the body, it can cause severe internal burns and can lead to death in as little as 2 hours. Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the battery, and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. The cells must be disposed of properly, including keeping them away from children. Even used cells may cause injury.

Outer Surface

Gently wipe off the dust with a soft, dry cloth.

Base

Press on the lock sign here and rotate counterclockwise to release the base from the fan, then press the tabs on the edges to detach the base halves from each other.

CAUTION

• Always unplug the fan before any cleaning or maintenance to avoid the risk of fire, electric shock, or injury to persons.
• Do not immerse in water or get water inside the motor housing.
• Do not use any chemical agents when cleaning the fan.
• Store in a cool, dry place and cover it to protect from dust.

Rear Grille

WARNING: Turn off the appliance and unplug before any cleaning and maintenance.

1. Remove the screw on the top of the rear grille with a Philips screwdriver.
2. Lift up the grille and pull it out.
3. Clean the dust on blades using a vacuum cleaner or air duster. Rinse the rear grille under running water or with a clean, damp cloth.
4. Dry up, then install the grille and the screw back by following the reverse order of disassembly.

User Servicing Instructions (Fuse)

This appliance features a fused safety plug that protects against overload or short-circuit situations. If the fuse blows, please cut off power and follow the below instructions or consult a qualified electrician.

1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Open fuse cover. Slide open fuse access cover on top of attachment plug towards blades.
3. Remove fuse carefully. Push the fuse from the other side to remove the fuse.
4. Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse.
5. Close fuse cover. Slide closed the fuse access cover on top of attachment plug.

WARNING: Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that should not be removed. Discard product if the attachment plug is damaged.

Troubleshooting

My fan won't turn on!

1. Make sure that the cord is connected to a powered outlet and the mains voltage corresponds with the voltage indicated on the fan.
2. Check if the fuse has blown. If the fuse has blown, please refer to page 13.

My fan is shaky and wobbling!

1. Place the fan on a flat, level surface.
2. Incorrect installation might also cause shakiness. Please refer to the assembly instructions in page 3-4. Note that the power cord must be run through all three keepers.

My fan is making vibration and noise!

1. Place the fan on a flat, level surface.
2. Be sure not to insert anything into the air inlet and outlet.

If your problem is not listed or still persists, please contact Dreo Customer Support (see page 15).

Dreo Customer Care

Default 12-Month Warranty

This appliance is covered by Dreo warranty for 12 months from the date of its original purchase.

Extend Your Warranty

Extend your warranty by registering your new appliance on our website https://dreo.com/warranty.

Warranty Exclusions

The warranty will not apply in cases of:

1. Accident, misuse, or repairs performed by unauthorized personnel.
2. Any unit that has been tampered with or used for commercial purposes.
3. Normal wear and tear of wearable parts.
4. Use of force, damage caused by external influences.
5. Damage caused by non-observance of the User Manual, e.g., connection to an unsuitable mains supply or noncompliance with the instructions.
6. Partially or completely dismantled appliances.
7. Defects caused by or resulting from damages from shipping or from repairs, service, or alteration to the product or any of its parts that have been performed by a repair person not authorized by Dreo.

Dreo can only provide after-sales service for products sold by Dreo or Dreo authorized retailers and distributors. If you purchased the appliance from a different place, please contact your seller for return and warranty issues.

Contact Information:

• Phone: (888) 290-1688
• Email: support@dreo.com (Mon - Fri, 9:00 am - 5:00 pm PST/PDT)
• Website: www.dreo.com

Company Information:

• Shenzhen Hesung Innovation Technology Co., LTD
• 26F, Bldg A7, Creative City, Shenzhen, China
• Made in China

Certifications: ETL LISTED, Intertek 5018396

Document Version: Rev 1.6 EN