TAC Truck Accessories Company | TACUSA
Installation Guide for TAC models including: 3S-F1122, 3S-F1122 3 Inch Side Bar, 3 Inch Side Bar, Side Bar, Bar
TAC Side Steps Fit 2015-2024 Ford F150 SuperCrew Cab & 2022-2024 F150 Lightning EV |2017-2024 F250/350/450/550 Super Duty Crew Cab Truck Pickup 3" Stainless Steel Side Nerf Bars 2pcs : Automotive
File Info : application/pdf, 4 Pages, 540.85KB
DocumentDocumentINSTALLATION INSTRUCTIONS 3" SIDE BAR 2015-2024 FORD F150 & 2022-2024 F150 Lightning EV SUPERCREW CAB 2017-2024 F250/350/450/550 SUPER DUTY CREW CAB PART# 3S-F1122 www.tacautoparts.com 90-DEGREE BENT END SIDEBARS 2015-2024 FORD F150 & 2022-2024 F150 Lightning EV SUPER CREW CAB 2017-2024 F250-550 SUPER DUTY CREW CAB PARTS LIST: 1 Driver/left Sidebar 1 Passenger/right Sidebar 2 Driver/left front-passenger/right rear Brackets 2 Passenger/right front-driver/left rear Brackets 2 Center Brackets (use for driver or passenger side) 18 8mm Plastic Washers 4 1/2" x 2" Hex Bolts 4 1/2" x 1-1/4" OD x 3/32" Flat Washers 4 1/2" Lock Washers 2 8-1.25mm x 25mm Hex Bolts 20 8mm x 24mm OD x 2mm Washers 2 8mm Lock Washers 18 8-1.25mm Nylon Lock Nuts (18) 8mm Plastic Washers Passenger/right rear Bracket (same as driver/left front) Driver/left rear Bracket (same as passenger/right front) (2) Center Brackets (driver side same as passenger) Passenger/right front Bracket (same as driver/left rear) Passenger/right Sidebar illustrated Driver/left front Bracket (same as passenger/right rear) Front step pad is farther away from end of tube Front PROCEDURE: REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED. 1. Start the installation under the driver side of the vehicle. Locate the front, center and rear factory running board mounting locations along the inner side of the body, (Figure 1). 2. Slide (1) Plastic Washer over each factory mounting stud in the body panel, (Figures 2 & 3). IMPORTANT: The Plastic Washers are designed to prevent corrosion between the aluminum body panel and the steel mounting brackets. Do not install the Brackets without the Plastic Washers. 3. Select (1) driver side front Mounting Bracket. NOTE: Same bracket is used for the passenger side rear installation. Attach the Mounting Bracket to the (3) factory studs with (3) 8mm Flat Washers and (3) 8mm Nylon Lock Nuts, (Figure 4). Snug but do not fully tighten the hardware. 4. Select (1) Center Bracket. Repeat Steps 1--3 to install the driver side center Bracket, (Figure 5). NOTE: Center Bracket is the same, driver side and passenger side. 5. Repeat Steps 1--3 to install the driver side rear Bracket, (Figure 6). NOTE: Same Bracket is used for the passenger side front installation. 6. Select the driver/left Sidebar. With assistance, position the Sidebar up to the front and rear Mounting Brackets. Attach the Sidebar to the Mounting Brackets with the included (2) 1/2" x 2" Hex Bolts, (2) 1/2" Lock Washers, and (2) 1/2" Flat Washers, (Figure 6). Leave hardware loose at this time. www.tacautoparts.com Page 1 of 3 8/12/16 (DP) 90-DEGREE BENT END SIDEBARS 2015-2024 FORD F150 & 2022-2024 F150 Lightning EV SUPER CREW CAB 2017-2024 F250-550 SUPER DUTY CREW CAB 7. Line up the threaded insert in the bottom of the Sidebar with the center Bracket. Attach the Sidebar to the Bracket with (1) 8mm x 25mm Hex Bolt, (1) 8mm Lock Washer and (1) 8mm Flat Washer, (Figure 7). Leave hardware loose at this time. 8. Level and adjust the Sidebar and tighten all hardware. 9. Repeat Steps 1--8 to install the passenger/right Sidebar. 10. Do periodic inspections to the installation to make sure that all hardware is secure and tight. To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be used also to clean the Sidebar. For gloss black finishes: Mild soap may be used to clean the Sidebar. Front (Fig 1) Locate the (3) factory threaded studs at each location. Driver side rear pictured Front (3) Plastic Insulation Washers (Fig 2) Plastic Insulation Washer (Fig 3) Thread Plastic Washers onto all mounting studs. Passenger side rear pictured www.tacautoparts.com Page 2 of 3 8/12/16 (DP) 90-DEGREE BENT END SIDEBARS 2015-2024 FORD F150 & 2022-2024 F150 Lightning EV SUPER CREW CAB 2017-2024 F250-550 SUPER DUTY CREW CAB Driver/left side installation pictured (3) 8mm Flat Washers (3) 8mm Nylon Lock Nuts Front (Fig 4) Driver side front Bracket installation Rear 1/2" x 2" Hex Bolts 1/2" Flat Washers 1/2" Lock Washers Front (Fig 5) Driver side center Bracket installation Front (Fig 6) Driver side rear Bracket installation 8mm x 25mm Hex Bolt 8mm Lock Washer 8mm Flat Washer (Fig 7) Driver side center Bracket installation www.tacautoparts.com Page 3 of 3 8/12/16 (DP)