Philips Hue Slim Recessed Light L
User Manual and Installation Guide
What's Included
- Philips Hue Slim recessed light L fixture [A]
- Driver/Power supply unit [B]
- Connectors
Tools Required (Not Included)
- Drill
- Drill bits
- Screws
- Wall plugs
- Pencil
- Phillips screwdriver
- Flathead screwdriver
Important Information & Ratings
- For indoor use.
- IP44 Rated: Protected against solid objects > 1mm and water splashes.
- IP20 Rated: Protected against solid objects > 12.5mm.
- Not for use with dimmers or electronic switches.
- Zigbee Certified Product ?
- Bluetooth Enabled ?
Installation Steps
Step 1: Prepare the Ceiling Hole
Turn off the power supply at the circuit breaker before starting installation. [Turn Power OFF] ?
Cut a hole in the ceiling with a diameter of Ø155 mm +/- 2 mm using a hole saw. [Diagram showing hole saw cutting a circle]
Step 2: Wiring the Driver
The driver unit has input terminals for mains power and output terminals for the light fixture. [Diagram showing driver unit with input/output labels]
Connect the power supply wires (2 x 0.75-1.0 mm²) to the input terminals. Ensure wires are stripped to 5.5 mm. [Diagram showing wire connection to driver terminals]
Alternatively, a wire with Ø6.0 mm can be used. [Diagram showing alternative wire connection]
Step 3: Install the Light Fixture
Ensure sufficient clearance above and around the fixture. Minimum 45mm clearance above the fixture is required. Total depth required is approximately 150mm. [Diagram showing correct clearance requirements]
Incorrect installation examples: Insufficient clearance above the fixture [Diagram showing insufficient clearance, marked X ❌]. Fixture tilted or not seated correctly [Diagram showing tilted fixture, marked X ❌].
Connect the light fixture cable to the driver unit. [Diagram showing hands connecting light cable to driver]
Insert the light fixture into the prepared ceiling hole. Ensure it is correctly oriented and seated. [Diagram showing correct insertion of fixture, marked ✓ ✔]
Warning: Do not place your hand near the fixture during installation or operation. [Diagram showing warning text]
Step 4: Restore Power
Turn on the power supply at the circuit breaker. [Turn Power ON] ?
The light should now be illuminated. [Diagram showing installed and lit fixture]
Technical Specifications & Information
- Manufacturer: Signify Holding
- Address: 5600 VB Eindhoven, the Netherlands
- Contact: 00800-74454775
- Website: www.philips-hue.com
- Product Identifier: 8720169264274-442296345361 (Philips Hue Slim recessed light L)
- Last Update: 11/2023
Support & Connectivity
For setup and connection, visit: www.philips-hue.com/connectproduct [QR Code Link]
For more information and support, visit: www.philips-hue.com [Support Link]
