Installation Guide for Built-in Dishwasher GV 640Voll-I

Preparation and Tools

This guide details the installation of the GV 640Voll-I, 86.5 cm built-in dishwasher. Ensure all parts are present and undamaged before starting. Required tools include a Torx T20 screwdriver and SW10, SW13 spanners. Recommended clearances and cabinet dimensions must be observed.

Key Installation Points:

• Weight Capacity: Components support 3.0-10 kg.
• Adjustments: Height and leveling adjustments are crucial, typically ranging from min. 70 mm to max. 120 mm, with some areas requiring greater than 120 mm clearance.
• Handling: Do not pinch components during installation. Ensure proper bracing.
• Water: Inlet pressure should be 0.05-1 MPa (0.5-10 bar), with a maximum temperature of 60°C. Flow rate is 10 liters/min.
• Final Check: Verify water tightness after the first wash cycle.

Installation Steps

Step 1: Cabinet and Appliance Overview

Diagrams show the dishwasher unit and the designated cabinet space. Measurements are provided for cabinet cutouts and clearances, such as minimum 70 mm and maximum 120 mm for leveling, and greater than 120 mm for other adjustments. Specific panel dimensions like 100x50 mm are indicated.

Step 2: Attaching Mounting Components

Attach mounting brackets or feet to the dishwasher using screws (e.g., 4x15). Some diagrams show removing a disc from a component before attachment.

Step 3: Inserting into Cabinet

Carefully slide the dishwasher into the prepared cabinet opening. Ensure correct alignment with cabinet edges.

Step 4: Securing the Appliance

Fix the dishwasher to the cabinet using screws (e.g., 4x30). Diagrams illustrate the screw points for securing the appliance firmly.

Step 5: Leveling and Alignment

Use the adjustable feet to level the dishwasher. Adjustments can range from 0-60 mm, with specific height requirements for the unit within the cabinet (e.g., 700 mm to 775 mm).

Step 6: Door Panel Installation

Attach the front decorative door panel to the dishwasher. This involves fitting hinges and ensuring the panel is correctly aligned and secured, often with specific brackets.

Step 7: Water and Drainage Connections

Connect the water inlet hose to the water supply and the drain hose to the drainage system. Diagrams show the connection points and required fittings.

Step 8: Electrical Connection

Connect the dishwasher to the electrical power supply. Ensure the connection is made safely and according to local regulations.

Step 9: Final Checks and Testing

Perform a final inspection. Check that all components are secure and that there are no obstructions. A leak test is essential after the first wash cycle.

Additional Specifications:

• Clearance: min. 18 mm, max. 1.1 m, min. 280 mm.
• Component dimensions: 26.4 mm, 20.9 mm.
• Part Numbers: Part No. 00622456, 00350564, 00657927, 12022522.
• Maximum appliance height: 775 mm.