Dals Lighting DCP-FLD30-BK Installation Guide
Important Safety Precautions
Read all instructions before beginning installation. Failure to follow these instructions could result in injury or damage to the product.
- Ensure the power supply is turned OFF at the circuit breaker before starting any electrical work.
- This product must be installed by a qualified electrician in accordance with local electrical codes.
- Do not install near flammable materials.
- Ensure the mounting surface can support the weight of the fixture.
- Avoid looking directly into the light source.
Package Contents
Verify that all parts are present before installation:
- Projector Fixture (DCP-FLD30-BK)
- Mounting Bracket
- Wire Connectors
- Screws
- User Manual
Installation Steps
-
Prepare the Mounting Location
Choose a suitable location for the projector. Ensure there is adequate space for mounting and wiring. Turn off the power supply to the installation area at the main electrical panel.
-
Mount the Bracket
Attach the mounting bracket to the chosen surface using the provided screws. Ensure the bracket is securely fastened.
-
Connect the Wiring
Connect the projector's wires to the corresponding wires in the electrical box using the provided wire connectors. Typically, this involves connecting the black wire (hot) to the black wire, white wire (neutral) to the white wire, and green or bare copper wire (ground) to the ground wire.
Wiring Diagram (Conceptual):
Projector Black Wire → House Black Wire (Hot)
Projector White Wire → House White Wire (Neutral)
Projector Green/Bare Wire → House Ground Wire
-
Attach the Projector
Carefully attach the projector fixture to the mounted bracket. Secure it according to the bracket's design, often by sliding or screwing it into place.
-
Restore Power and Test
Once the fixture is securely mounted and wired, restore power at the circuit breaker. Test the projector to ensure it is functioning correctly.
Maintenance and Care
Clean the projector lens periodically with a soft, dry cloth. Avoid using abrasive cleaners or solvents.
Troubleshooting
Projector does not turn on:
- Check if the power supply is on.
- Verify all wiring connections are secure and correct.
- Ensure the circuit breaker is not tripped.
Flickering light:
- Check wiring connections for looseness.
- Ensure compatibility with the dimmer switch if used.
Product Information
Model: DCP-FLD30-BK
Brand: Dals Lighting
Voltage: [Specify Voltage, e.g., 120V]
Wattage: [Specify Wattage, e.g., 30W]
Color Temperature: [Specify Color Temperature, e.g., 3000K]
Lumens: [Specify Lumens]
IP Rating: [Specify IP Rating, e.g., IP65]
Contact Information
For further assistance or inquiries, please visit Lumenco.ca.
