MyBabiie MB240 Pushchair

Chassis

The main frame of the pushchair.

Seat unit

The part where the child sits.

Front wheels

Two wheels at the front of the pushchair.

Rear wheels

Two wheels at the rear of the pushchair.

Rain cover

A cover to protect the child from rain.

Hood visor

An extension to the hood for extra sun protection.

Unfold the stroller

Take the chassis from the carton. Unfold the chassis by stepping on the rear tube and pulling upward on the handlebar. Lean forward until the folding hinge is fully engaged. The folding mechanism will lock into place when the legs are fully extended. You should hear a clear "click". [Lift the pushbar]

Front & Rear Wheels Assembly

1. Install front & rear wheels: Push the wheels into the wheel housing until they lock into place. You should hear a clear "click". Note: Pull the wheels to ensure that they are securely attached to the chassis.
2. Fix the direction of front wheels: Put the front wheels in the forward direction and press down the fixer. You should hear a clear "click". Pull up the fixer and the wheel can rotate freely.
3. Remove the front & rear wheels: Push the release button on the side of the front wheel hub and remove the front wheel. Pull the release pin on the side of the rear wheel hub and remove the rear wheel.

Seat Assembly

Unfold the seat, then install the hood visor on the hood by using the zipper. Align the seat with the anchors on the side of the chassis and push them together until they install securely. You should hear a clear "click". Extend the hood to its opening condition and adjust the hood freely according to your desired position.

Seat direction adjustment

The seat can face in either direction, forward or backward. Press the release button on each side to take out the seat and adjust the direction of the seat. Note: Do not adjust the seat direction with the baby inside.

Seat backrest adjustment

To recline the backrest, pull the lever on the back of the seat and lower the seat to your required position. To raise the seat, simply push the backrest up.

Footrest adjustment

Press the adjustment button on the two sides of the footrest at the same time to adjust up or down.

Handle bar adjustment

To lower or raise the push handle on the pushchair, press in the buttons on either side and rotate the bar to your preferred position.

Brake operation

To engage the brake, push the brake lever down with your foot. The stroller might need to be rolled back and forth to fully engage the brake. Check that the stroller will not move once the brakes are properly applied. Release the brake by pushing the brake lever up. [1. Engage the brake] [2. Disengage the brake]

5-point safety harness

Insert the shoulder strap buckle 1 into the buckle housing of the center hub. Repeat for the other side 2. Insert the completed waist buckle 3+4 into the buckle housing too. Ensure all the buckles engage the housing securely in place. To release buckles, press the center button on the buckle housing. [Round release button] [Safety belt length adjustment]

1&2: Shoulder belt length adjustment

3&4: Waist belt length adjustment

5: Crotch belt length adjustment.

The shoulder straps of the 5-point harness have 2 attachment positions. Select the position that places the shoulder strap level with, or below the child's shoulder. To adjust harness height, unhook the shoulder strap from the crotch buckle. Insert the shoulder strap through the harness spread slots. Insert shoulder strap through the appropriate slot and reattach the shoulder strap to the crotch buckle.

To fold the stroller

Pull the stroller backward several inches to adjust the front wheels to the front, then fix the front wheels. Lift the release button on the canopy and push forward on the rear edge of the hood toward the floor. Secure the stroller in the folded position by pushing the handlebar backwards to be level with the rear frame. You should hear a "click". The stroller can be self-standing after folding. Note: The stroller can be folded in parent facing position.

Cleaning & washing

Please note the textile designation. Metal and plastic parts should be cleaned with a damp cloth and mild detergent. Do not use abrasive agents. Please check on a regular basis that the brakes, wheels, latches, connecting elements, belt systems, and seams are properly functional.

In case of any damage or irregularities, the product no longer use. Don't expose the product to strong sunshine. After use in rain or snow, the wheels should be lubricated and the vehicle dried to prevent rust. Care for, clean, and check this product regularly. Don't use accessories that have not been approved by the manufacturer.

For the proper functioning of the pushchair, MyBabiie recommends regular cleaning and lubrication of all moving parts, mechanisms, and wheel axles with the appropriate cleaning agents and lubricants.

Do's:

• Do use your brakes! Ensure the parking brake is engaged during the loading and unloading of children & when the stroller is stationary.
• Do always use the restraint system! Ensure that the child restraint system is correctly fitted at all times.
• Do keep your stroller clean and dirt free. Use a clean white cloth, warm water and a mild detergent to keep your stroller clean.
• Do always keep two hands on the handles when pushing. You could lose control of your stroller if not steering with both hands.
• Do follow manufacturers instructions when assembling and using your stroller. For safety, please refer to our instruction manuals or contact customer support if you're unsure.

Don'ts:

• Don't use your stroller up and down stairs! Don't use your stroller up or down stairs or to bump kerbs.
• Don't hang bags off the handles! Bags and other items should not be hung from the handles as this can affect the stability of the stroller.
• Don't run or skate with your stroller! Our products are not suitable for running or skating.
• Don't carry the stroller with baby inside! Our strollers are not designed to be carried with your baby inside them.
• Don't put hot drinks in the cup holder. Hot drinks burn and can easily spill from the bottle holder.
• Don't jetwash your stroller. Some jet washers are very powerful and could damage parts of your stroller!
• Don't leave your child un-attended in their stroller. Always keep your child and stroller in view to avoid accidents.
• Don't treat your stroller like a trolley. Don't load your stroller up with all your shopping as they are not built for this purpose and could cause damage.
• Don't use your stroller as a bumper cart! Damage can easily occur if your stroller is knocked into other things.
• Don't smoke around your stroller. We wouldn't want your stroller or little one getting hurt or damaged!
• Don't leave your stroller unattended on extreme gradients. Even with your brakes on, your stroller is at risk from tipping or sliding on extreme gradients!
• Don't sit in the strollers unless the user is under the guideline weight. Our strollers are designed to hold a maximum weight. If exceeded, this will cause damage!

Enjoy your product!

Go out and have fun adventures with your little one!