Parts Included
Assembly Instructions
Step 1: Connect Pole Sections
Insert a connecting piece into Pole A. Align its holes with the pole and tighten with two screws.Take a Pole B section, align its metal slots with the holes of the connecting piece, and tighten with two screws.Ensure the two pole sections are closely aligned and tightened. Repeat this process for the remaining Pole B sections.
Tips: Before tightening the screws, ensure the two poles are held firmly together to avoid large gaps that might cause incline or light leak.
Step 2: Attach Pole Assembly to Base
Slide the metal slots of the assembled pole section onto the base. Tighten with two screws.
Step 3: Connect Silicone Strip Light
Straighten the silicone strip light. Connect the wires on the silicone strip light to the corresponding wires in the lamp base. Ensure wires are connected by color.
Step 4: Install Strip Light and Power Up
Ensure the exposed wires are neatly tucked inside the lamp base. Attach the silicone strip light by carefully pressing it into the designated channel on the lamp pole, starting from the middle and working outwards to the ends. Connect the power adapter to the cable of the lamp base and plug the adapter into a power outlet.
Troubleshooting
1. The silicone light strip is too long.
- Take out the strip from the pole.
- Follow Step 4 to reinstall.
Note: To avoid deforming the silicone light strip, please press from the top and bottom first, and then press the middle.
2. After installing all the poles, the gap between them is large or they are skewed.
- Remove the screws and connecting pieces.
- Follow Step 1 to Step 2 to reinstall.
