VEVOR Motorcycle Carrier

IMPORTANT SAFEGUARDS

⚠️ Read and understand this entire manual before assembling, installing, operating, or servicing this product. Failure to follow these warnings and instructions can cause death, personal injury, or damage to valuable property.

1. Adhere to all Department of Transportation (D.O.T.) requirements when using this product.
2. Use common sense when working. Stay alert and concentrate when setting up and using this product. Never work while under the influence of alcohol, drugs, or medications.
3. While assembling and using this product, keep the work area clean and well-lighted. Keep spectators and children out of the work area.
4. Dress appropriately. Never wear loose-fitting clothing or jewelry when working. Contain long hair, and keep hair, clothing, and gloves away from moving parts.
5. Always keep this stand away from children.
6. Check the stand is in good condition before using it.

SAVE THESE INSTRUCTIONS

PRODUCT PARAMETERS

ASSEMBLY

Step 1:

[Diagram: Two brackets (A) attached to a hitch bar (B)]

Install the support brackets (A) onto the hitch bar (B) on the outside of the welded brackets using 4 pcs M8x20 Bolts (H). Leave bolts hand tight.

Step 2:

[Diagram: Motorcycle racks (C) being attached to the support brackets with bolts (G), washers (I), and nuts (J)]

Place the motorcycle rack (C) between the support brackets and install 4 pcs M8x40 bolts (G), washers (I), and nuts (J). Securely tighten all 8 pcs support bracket bolts. Install the other motorcycle rack platform rotated 180° of the first motorcycle rack platform and repeat Steps 1 & 2.

Step 3:

[Diagram: Hitch bar inserted into a trailer hitch with a hitch pin (L) and an anti-tilt bracket (F) being attached]

Insert the hitch bar into the trailer hitch and install the hitch pin (L). Put the "U" size steel down to the hitch bar, then assemble the bracket as shown in the picture. Slide the anti-tilt bracket (F) towards the vehicle and tighten the bolts evenly. This will pinch the bracket on the collar of the hitch, preventing excessive movement of the rack.

Step 4:

[Diagram: Ramp (D) stored on the hitch bar with screws (E)]

The ramp (D) stores on the hitch bar with 2 PCS M10x25 screws (E).

Ramp Usage

[Image: Motorcycle being loaded onto the carrier using the ramp. Close-up images of the ramp connection.]

Put the ramp on the motorcycle rack. Motorcycles can move along the ramp.

Step 5:

[Diagram: Lock pin (K) inserted into the front of the motorcycle rack]

The optional lock pin (K) can be inserted into the front of the motorcycle rack to make the front wheel gap smaller.

Step 6:

[Image: Motorcycle secured to the VEVOR carrier with tie-down straps (M)]

Secure each motorcycle to the rack with tie-down straps (M). Use two ratchet straps attached to the handlebars, two straps attached to the rear frame of the bike, and two wheel ties.

Ratchet Belt Use Method

A. Installation And Tightening

[Image sequence showing how to thread and tighten a ratchet strap]

1. Thread the tail of the webbing from the outside in under the center slot.
2. Thread the tail of the webbing through the center slot.
3. Pull the tensioner handle back and forth.

B. Unraveling Method

[Image sequence showing how to release a ratchet strap]

1. Use your hand to pull the spring buckle on the handle.
2. Open the handle in a zigzag position.
3. Pull out the webbing here to untie it.