Philips AWP2980 Next-Generation Instant Water Filter

Important Information

Users should carefully read this important information before using the device and save it for future reference.

Warning

• This device is intended to filter tap water only. Do not put water of unknown quality or that has been microbiologically unsafe into the device.
• This device is designed to be used with water temperatures between 2-38℃ (32-95°F).
• Do not put the device in the dishwasher for cleaning.
• Do not subject the device to impact or falls, as this may affect its normal function.
• If the tap water is turbid, run the tap water for a while before filling the water tank to ensure filter lifetime.
• The filter may be moist due to the evaporation of water from the resin, which is normal and does not affect use.
• According to water quality and actual usage in different regions, the filter should be replaced regularly.
• Do not immerse the device in water.
• Keep the device away from direct sunlight or any other heat source. Do not expose the device to moisture.
• Do not charge this device for a long time to avoid damage to the battery.
• To ensure battery life, charge the device frequently to maintain sufficient power.
• Filtered water should be consumed within 24 hours.
• Do not put this product in the freezer, as it may cause damage to the product.

Using the Device

Cleaning instructions before use

Display Indicators

Press the button to start dispensing filtered water, and press it again to stop. The device will stop automatically in 1 minute. If the tank is low on water, the device will not respond even if the button is pressed.

Filter Lifetime Indication and Replacement

• With usage-based filter lifetime monitoring, the indicator will show constant purple light to remind users to replace the filter after 100L or every 30 days, whichever comes first.
• When the filter lifetime is less than 3 days or the remaining filtration capacity is less than 6L, the indicator will flash purple light to notify.
• Filter lifetime reset: Press and hold the dispense button for 8 seconds. When the filter lifetime reset is completed, the indicator light will flash blue light 3 times.
• To prevent the filter from drying out, it should not be left unused for long periods. If an extended period is anticipated (such as a holiday), it is recommended to remove the filter and store it in a sealed plastic bag before putting it in the refrigerator (not the freezer).
• If the filter has not been used for more than 5 days, discard 3L of water to flush the filter media. If it has not been used for more than 15 days, the filter should be replaced.
• Store the device completely dry when it is expected to be unused for a long period.

Maintenance

Wash and rinse the tank regularly. Remove the filter and discard all water before cleaning. The lid should be wiped clean with a damp cloth. Only use mild cleaning agents; never use solvents, corrosive chemicals, or abrasive pads on this device.

Guarantee & Service

For information or questions, users can visit the Philips website at www.philips.com/water or contact the consumer care center in their country. If there is no consumer care center in a specific country, users should go to the local dealer.