PDMICKT34 Wired Microphone Kit

Connecting and Disconnecting the Microphone Cable

1. Insert the XLR connector into the microphone. If necessary, rotate the connector to align the key on the connector and the groove in the microphone, push the connector into the microphone until it clicks.
2. To disconnect the cable and microphone, grasp the connector while depressing the tab. Pull the connector away from the microphone.

Usage

Diagram illustrating optimal microphone placement. A sound source is positioned in front of a microphone, with a loudspeaker and stage monitor shown to the sides. The diagram indicates that the microphone should be aimed directly at the sound source (0° axis) for best performance, with undesired sound sources positioned away from the microphone.

For the best gain-before-feedback and isolation from undesired background noise, aim the microphone toward the sound resource and away from undesired sound resource.

2. Do not cover any part of the grille with your hand, covering the grille alters the sound and distorts the polar pattern increasing the chance for feedback.
❌ [Incorrect Handling] ✔️ [Correct Handling]

Features

• Includes (3) Handheld Microphones & (3) XLR Audio Cables
• Built-in Acoustic Pop Filters
• Ultra-Wide Frequency Response
• High Signal Output for Vocals & Singing
• Rugged Construction & Steel Mesh Grill
• Reinforced Sound Cartridge
• ON/OFF Switch for Stage Control
• Perfect for Stage Performances or In-Studio Use

Technical Specs

• Mic Element: Hyper-Cardioid
• Pickup Pattern: Unidirectional Moving Coil
• Mic Construction Material: Zinc Alloy
• Audio Cable Connectors: XLR to 1/4"
• XLR Cable Length: 26'+ Ft.
• Open Circuit Sensitivity: -54 dB
• Frequency Response: 60Hz-15kHz
• Output Impedance: 600 Ohm, +/-3dB (0dB=1V/Pa @ 1kHz)

Frequency Response Graph: This graph displays the Average Response in decibels (dB) across a frequency range from 20 Hz to 200 kHz. The curve shows a typical microphone response, generally flat within the audible range, with some variation at the lower and higher frequencies.

Cautions

1. If the head of the microphone is covered by hand or brought close to the speaker, a howling sound may be generated. To prevent this, first decrease the volume, then place the microphone so that it is not pointed to the speaker and that there is a sufficient distance between the microphone and speaker.
2. It is important to keep foreign particles out of the grill and the windscreen because they may alter the frequency response of the microphone. The grill shall be periodically cleaned using warm, soapy water, rinsed with plain water and let dry before replacing.
3. Due to the high sensitivity of the cartridge, do not drop it from high or apply strong shock to it.
4. To maintain the sensitivity and quality of sound reproducing, avoid exposing it to moisture and extreme temperatures.