NYSJÖN Mirror with Shelf
Product Model: AA-2246804-2
Important Safety Information
Wall mounting should be performed by a qualified person. Incorrect mounting can lead to the mirror tipping over or falling, resulting in personal injury or damage.
⚠️ NOTE! Screws or fittings to fix the mirror to the wall are not included, as wall materials vary. Choose screws and fittings that are specially suited to the material in your wall and have sufficient holding power.
If you are uncertain, contact your local specialised retailer.
Assembly Instructions
Step 1: Mark Wall Placement
Measure and mark the wall. Use a spirit level to ensure accuracy. The recommended distances are 400 mm (15 3/4") horizontally and 575 mm (22 5/8") vertically for the main bracket placement. This step is illustrated by diagrams showing a spirit level, pencil, and tape measure, with lines indicating measurements on a wall.
Step 2: Prepare Mounting Brackets
Prepare the two main shelf support brackets (part 10062053). Insert six small circular alignment pieces (part 107091) into the designated holes on each bracket. Press them firmly into place. This is shown with diagrams illustrating the brackets and the insertion of the small circular parts.
Step 3: Attach Brackets to Wall
Position the prepared brackets on the wall at the marked points. Secure them using appropriate screws and wall anchors (not included). Ensure they are firmly attached and have sufficient load-bearing capacity. The diagram shows the brackets being screwed into the wall.
Step 4: Attach Shelf Supports
Slide the shelf support pieces (part 120040) onto the wall-mounted brackets. Ensure they are fully inserted. Diagrams show these pieces sliding onto the mounted brackets.
Step 5: Install Wall Mounts
Attach the circular wall mounts (part 139299) to the wall. Use screws suitable for your wall material (not included). ❌ Important: Do not use a drill for this step. The screw length should not exceed 3.5 mm (1/8"). Diagrams illustrate this process, including a warning symbol and a measurement for screw length.
Step 6: Attach Mirror Holders
Attach the mirror holder clips (part 139298) to the circular wall mounts. Slide them downwards onto the mounts until they click into place. Diagrams show the clips being attached to the mounts.
Step 7: Hang the Mirror
Carefully lift the mirror and place it onto the shelf support pieces. Ensure it rests securely on the supports. Diagrams show a person lowering the mirror onto the supports.
Step 8: Secure the Mirror
Secure the mirror to the shelf supports using the provided clips. Press the clips down firmly to lock the mirror in position. Diagrams illustrate the clips being pressed down.
Step 9: Attach the Shelf
Slide the shelf into its designated position on the lower part of the mirror assembly. Ensure it is fully seated and secured. Diagrams show the shelf being slid into place and secured.
