Aqara Smart Wall Switch

Product Profile

Product Name: Smart Wall Switch (No Neutral, Single/Double Rocker)

Push Button:

• Short Press Once: Turn on/off
• Long Press for 5s: Reconnect
• Quick Press 3 Times: Effective Range Test

Indicator Light:

* This product requires a compatible hub. Some features require a specific hub. For the detailed list, please visit: www.aqara.com/support

Warning

A certain amount of electrical knowledge is required to install a smart wall switch. For your safety, it is recommended to ask a qualified electrician to help you install it.

• This product is for indoor use only; do not use it in a humid environment.
• Do not install this product near a heat source.
• IMPORTANT!: This Smart Switch is rated for and intended to only be used with copper wire.

Before Installation

This product is only used to replace a single pole switch rather than a 3-way switch.

Installation

For more information, visit: www.aqara.com/support

1. Turn off power at the circuit breaker or fuse box and test that power is off before wiring. (Switch the light several times to ensure power is disconnected).
2. Remove the existing switch and identify the wires using wire labels.
   • Ground: Usually green/bare.
   • Neutral: Usually white.
   • Line (Hot)/Load: Required, usually black, and always present.
3. Install the smart wall switch and connect the wires as required.
4. Tuck the wires into the wall box, leaving room for the smart switch. Using the provided screws, mount the smart switch to the wall box. Be careful not to crush any wires. (Note: avoid overtightening the screws.)
5. Install the wall plate, turn main power ON at the circuit breaker, and test the switch by pressing the button.
   • If it doesn't work, check: a. If the wiring is correct; b. If the power is restored.
   • If it works, proceed to add the switch to the app.

Quick Setup

1. Add the Hub to the app according to the Hub Quick Start Guide.
2. Open the app, tap "+" in the top right corner to enter the "Add Device (Accessory)" page. Select "Smart Wall Switch (No Neutral, Single/Double Rocker)" and follow the instructions to add it.

*If the connection fails, move the hub closer to the switch, connect to power, and try again.

Effective Range Test: Quick press the button on the device 3 times. If the Hub makes voice prompts, it indicates effective communication between the device and the Hub.

Specifications

Manufacturer Information

Manufacturer: Lumi United Technology Co., Ltd.

Address: 8th Floor, JinQi Wisdom Valley, No.1 Tangling Road, Liuxian Ave, Taoyuan Residential District, Nanshan District, Shenzhen, China.

Online Customer Service: www.aqara.com/support

Email: support@aqara.com

Compliance Information

Federal Communications Commission (FCC) Compliance Statement

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.

2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

IC Notice to Canadian Users

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

This Class B digital apparatus complies with Canadian ICES-003. This device complies with RSS-247 of Industry Canada. Operation is subject to the condition that this device does not cause harmful interference.

L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) L'appareil ne doit pas produire de brouillage; (2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Cet appareil numérique de la Classe B conforme à la norme NMB-003 du Canada. Cet appareil est conforme à la norme RSS-247 d'Industrie Canada. Le fonctionnement est soumis à la condition que cet appareil ne provoque pas d'interférences nuisibles.

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Cet équipement est conforme aux limites d’exposition aux rayonnements de la IC établies pour un environnement non contrôlé. Cet équipement doit être installé et fonctionner à au moins 20cm de distance d’un radiateur ou de votre corps. Cet émetteur ne doit pas être co-localisé ou fonctionner en conjonction avec une autre antenne ou un autre émetteur.

Important Safety Instructions

English:

1. The maximum ambient temperature during use of the appliance must not exceed 40° C.
2. The appliance is suitable for moderate climates only.
3. The appliance does not require much attention. If you want to clean it, please use only dry cloths or a brush.

Spanish:

1. La température ambiante maximale pendant l'utilisation de l'appareil ne doit pas dépasser 40° C.
2. L'appareil est uniquement adapté aux climats modérés.
3. L'appareil ne nécessite pas beaucoup d'attention. Si vous souhaitez le nettoyer, utilisez uniquement des chiffons secs ou une brosse.