Maytag Dryer Dimension Guide
Models: MED6500MBK, YMED6500MBK, MED6500MW, YMED6500MW (Electric); MGD6500MBK, MGD6500MW (Gas)
Detailed Planning Dimensions
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS and INSTALLATION INSTRUCTIONS, located in your appliance's Owner's Manual, before installing and operating this appliance.
The following tables and diagrams provide detailed dimensions for Maytag electric and gas dryers.
Electrical Requirements
| Fuel Type | Electric | Gas |
|---|---|---|
| Minimum Circuit Amperage Rating | 30 A | 15 A |
| Maximum AMP Draw | 26 A | 6 A |
| Operating Voltage | 120/240 V - AC only | 120 V - AC only |
| Current Canada Rating | 24 A | N/A |
| Operating Frequency | 60 Hz | 60 Hz |
Product Dimensions
Refer to the diagrams below for the corresponding dimensions.
Front and Side Views (Electric and Gas)
Diagrams show front, side, and top views of the dryer with labels A through G indicating specific measurements.
| Label | Dimension Description | Inches (in) | Millimeters (mm) |
|---|---|---|---|
| A | Height (With leveling legs not extended) | 40 11/16 | 1034 |
| B | Width | 29 | 737 |
| C | Top Height (with min. feet) | 36 7/8 | 937 |
| D | Depth | 28 3/8 | 722 |
| E | Top Height (With leveling legs fully extended) | 38 1/2 | 978 |
| F | Height (With leveling legs fully extended) | 42 5/16 | 1075 |
| G | Depth with Door Open | 50 11/16 | 1288 |
Rear Views (Electric and Gas)
Diagrams show rear views of the electric and gas dryers with labels H through T indicating specific measurements related to connections and clearances.
| Label | Dimension Description | Inches (in) | Millimeters (mm) |
|---|---|---|---|
| H | Strain Relief from Side (elec) | 15 3/4 | 400 |
| I | Strain Relief Height (elec) (With leveling legs not extended) | 28 1/8 | 714 |
| J | Exhaust Duct from Side | 14 7/16 | 366 |
| K | Power Cord from Side (gas) | 14 3/4 | 375 |
| L | Power Cord Height (gas) | 32 3/8 | 822 |
| M | Gas Connection (With leveling legs not extended) | 1 11/16 | 43 |
| N | Gas Connection from Side | 9 3/16 | 234 |
| O | Strain Relief Height (elec) (With leveling legs fully extended) | 29 3/4 | 755 |
| P | Exhaust Duct Height (With leveling legs fully extended) | 6 11/16 | 170 |
| Q | Gas Connection (With leveling legs fully extended) | 3 5/16 | 84 |
| R | Exhaust Duct Height (With leveling legs not extended) | 5 1/16 | 128 |
| S | Water Inlet Height (on steam models only) | 32 1/8 | 816 |
| T | Water Inlet from Side (on steam models only) | 4 | 101 |
| Gas Power Cord Length | 60 | 1525 | |
| Power Cord Length (Canadian) | 52 3/8 | 1330 |
Spacing for Recessed Area or Closet Installation
The dimensions shown are for the recommended spacing allowed. Consider additional spacing for ease of installation and servicing, as well as for wall, door, and floor moldings.
- An additional spacing of 1" (25 mm) on all sides of the dryer is recommended to reduce noise transfer.
- For closet installation with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable.
- Companion appliance spacing should also be considered.
Diagram shows a dryer installed in a recessed area or closet, illustrating recommended clearances and ventilation openings.
Key Spacing Dimensions:
- Maximum depth clearance: 14" (356 mm)
- Side clearance (minimum/recommended): 6"/0" (152 mm/0 mm)
- Front clearance (minimum/recommended): 1"/0" (25 mm/0 mm)
- Rear clearance: 18" (460 mm)
- Top ventilation opening: 48 in² (310 cm²)
- Bottom ventilation opening: 24 in² (155 cm²)
- Minimum clearance from back of dryer to wall: 1" (25 mm)
