Calculite LED Accessories

Important Safety Information

⚠️ CAUTION:

The installation and servicing of this product should be performed by a qualified electrician or service personnel.

FCC Compliance

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Installation Steps

Tools and Accessories Needed (Not Included)

• (2) 8-32 Hexagonal Keps Nut

Step 1: Prepare the J-BOX DOOR

Take the BSL06M5 component and place it into the J-BOX DOOR EM. Align the holes with the ports to make the necessary connections, as depicted in Figure 1. Secure the BSL06M5 to the J-BOX DOOR EM by fastening the 8-32 Hexagonal Keps Nut, as shown in Figure 2.

Figure 1: BSL06M5 placement in J-BOX DOOR EM with connections aligned.

Figure 2: Securing BSL06M5 with Hexagonal Keps Nut.

Step 2: Access the J-BOX

Locate the J-BOX DOOR. Lift the lance and pull the door open, as illustrated in Figure 3.

Figure 3: Removing the J-BOX DOOR.

Step 3: Wiring Connections

Connect the power leads: Wire the neutral supply lead to the white wire, the hot supply lead to the black and/or white & red wires (depending on whether the application uses a switch), and the bare copper and/or green wire to the supply ground. Use wire nuts (local hardware item). Place all electrical connections within the j-box. For luminaires with 0-10V dimming or digital dimming, connect the violet and gray leads to the appropriate control wires. The additional orange wire is for future expansion and should remain capped off, as shown in Figure 4.

Figure 4: Wiring diagram showing connections for Battery Pack, LED, Driver, AC Driver, Line, Neutral, and Ground.

Step 4: Install the Battery Pack Door

Insert the lower tab of the J-BOX DOOR EM into the hole of the J-BOX and push until the lance secures the door. Place the J-BOX DOOR EM, with the BSL06M5 attached, into the position where the original J-BOX DOOR was, as shown in Figure 5.

Figure 5: Installing the J-BOX DOOR EM with BSL06M5.

Test Switch Mounting Instructions

Ceiling Test Switch Mounting

To mount the test switch to the ceiling: Cut a hole in the tile ceiling as indicated (Figure 7). Push the ceiling plate through the hole until it stops. Screw the ceiling plate in place and pass the button harness cable through the hole of the ceiling plate. Finally, secure the button harness cable with the hex nut (Figure 6).

Figure 6: Securing button harness cable with hex nut.

Figure 7: Ceiling test switch mounting diagram.

Reflector Test Switch Mounting

To mount the test switch to the reflector: Disconnect the button harness cable from the emergency battery by releasing the connector lock (Figure 8). Pass the button harness cable through the reflector (Figure 9) and secure its position with the hex nut. Reconnect the button harness to the emergency battery.

Figure 8: Releasing connector lock.

Figure 9: Passing button harness cable through reflector.