Anko

Product Contents

The product package includes:

• One mesh barrier
• Four metal poles
• Four adhesive hooks
• Adhesive strips

Assembly Instructions

Step 1: Prepare the Poles

Extend the metal poles and insert them into the short sides of the mesh barrier. A visual shows a hand inserting a metal pole into the side of the mesh barrier, which is laid flat. The barrier is shown fully assembled with poles inserted.

Step 2: Position and Mount Hooks

Unfold the mesh barrier and position it on the wall where you wish to install it. Mark the spots for the adhesive hooks.

Remove the backing liner from the adhesive hooks and press them firmly onto the wall at the marked spots for a few seconds. A visual shows a hand peeling the backing off a Command adhesive hook. Another visual shows a hand pressing an adhesive hook onto a wall.

Ensure the hooks on the bottom are oriented horizontally.

Step 3: Attach Barrier to Hooks

Take the corner loops of the barrier and place them around the installed hooks. A visual shows the corner loops of the mesh barrier being attached to the wall-mounted hooks.

Step 4: Removing the Barrier

To remove the barrier, slide the hook up and off its mount. Then, press the back base of the hook while pulling the adhesive strip straight upwards. This method ensures the hook and adhesive are removed cleanly, leaving no holes, marks, sticky residue, or stains. A visual shows a hand sliding a hook upwards to detach it from its mount. A visual shows a hand pulling an adhesive strip straight up to remove it from the wall.

Important Warnings

WARNING:

Please test the surface of your walls prior to use. Some older paint surfaces are not designed for adhesive products.

Inspect the barrier and its mounting regularly and remove it immediately if any damage is observed.

Always supervise your pet while the barrier is in use.