Anko

Parts List

• A. Long rail x 2 pcs
• B. Short rail x 2 pcs
• C. Mat x 1 pc
• D. Screw x 4 pcs
• E. Hex key x 1 pc

Assembly Instructions

Step 1

Insert the longer side rails (A, 2 pieces) through the pockets on the long side of the mat (C). Insert the short side rails (B, 2 pieces) through the pockets on the short side of the mat (C).

[Diagram: Four rails being inserted into the fabric mat pockets.]

Step 2

Align the curved end of the shorter side rails with the screw hole on the longer rail. Hand-fasten with the provided screws (D, 1 piece) and the Hex key (E). Do not tighten at this stage.

[Diagram: Close-up showing a screw being inserted with a hex key to connect a short rail to a long rail.]

Step 3

Repeat Step 2 for the remaining screw holes until all four sides are connected. Use the provided Hex key (E) to tighten all screws. Do not over-tighten.

[Diagram: Image of the fully assembled elevated dog bed with all four legs attached.]

WARNING

Do not place fabric near a fire or open flame.

For your pet's safety, inspect regularly and remove if damaged.

Ensure the product is tightened prior to giving it to your pet for use.

Maximum loading: 45kg