BELIFE Vacuum Cleaner
Love life as it is
Contact Us
For any questions:
? Belifehome@outlook.com
? 401-300-0032 (9AM-5PM CDT WEEKDAY)
Assembly
Align the main body, extension rod, and cleaning tool as shown. Insert until they "click". To remove any attachments or accessories, press and hold the button, then pull to remove.
Note: All attachments included are compatible with the main body and the extension rod.
Operation
Turn on the vacuum cleaner:
- Pull the trigger to turn on. Standard suction mode is the default.
- Pull the trigger again to switch it off.
Suction level selector: Adjust suction power using the selector.
Troubleshooting
The following table outlines common issues and their solutions:
| Indicator | Meaning | Suggested Solutions |
|---|---|---|
| Suction blockage indicator | Suction blockage | Clean filter regularly. Remove hair and foreign objects from the brush. Remove compressed hair strains from the bearing (refer to Maintenance section). Check and remove any foreign object at the floor brush, extension rod, main body air inlet, and dirt bin. Follow instructions on pages 3-4 to clean and keep inlet/outlet air ducts free from blockage. |
| Brush stuck indicator | Brush stuck | Remove any foreign objects that cause the brush to cut off power automatically. If there is no foreign object (it may have dropped off), restart the vacuum. |
| Voltage problem indicator | Voltage problem | This problem is caused by a faulty battery. Please contact BELIFE, and a replacement battery will be provided. |
| Digital Display Panel (all indicators on) | Voltage problem | This problem is caused by a faulty battery. Please contact BELIFE, and a replacement battery will be provided. |
| Digital Display Panel (screen not light up after a few seconds when fully charged) | Faulty battery | This problem is caused by a faulty battery. Please contact BELIFE, and a replacement battery will be provided. |
Note: If you have any other questions, please contact BELIFE, and they will assist you.
Mode Suggestions
| Mode | Runtime | Suitability |
|---|---|---|
| Min Mode | 40 min runtime | Suitable for hair and dust on wood floor or tile. |
| Mid Mode | 30 min runtime | Suitable for fine dust and hair on low pile carpet. |
| Max Mode | 10-15 min runtime | Suitable for dog food, coffee beans, and other large particles on low pile carpet. |
Cleaning the Cyclone Unit
Cleaning frequency: Whenever needed.
1. Pull the pull ring fully.
2. Lift the dirt bin.
3. Remove the dirt bin.
4. Gently pull to separate the cyclone unit from the dirt bin.
5. Brush the cyclone unit to remove debris and dust.
Alternatively: If necessary, wash with cool water and air dry completely for 24 hours.
WARNING: Never attempt to disassemble the sealed cyclone unit.
Cleaning the HEPA Filter
Cleaning frequency: 3-6 months or whenever airflow is weak.
1. Turn the HEPA filter anti-clockwise to remove.
2. Wash with cool water.
3. Dry completely.
Cleaning the Pre-motor Filter
Cleaning frequency: 1-2 months or whenever airflow is weak.
1. Gently pull out the filter.
2. Wash with cool water. Hand massage with soap if needed.
3. Dry completely (allow 12 hours).
WARNING:
- DO NOT brush any part of the porous filtration material.
- DO NOT soak any filter in water for more than 10 minutes.
- DO NOT wash any other part of the vacuum except the specified filter assembly.
Cleaning the Brush and Bearing
1. Pull to release brush locking clip.
2. Remove brush locking clip.
3. Lift to remove the roller brush.
4. Remove debris on the small rollers with a pair of tweezers.
5. Gently pull to remove the brush bearing cap.
6. Remove any debris on the shaft.
7. Apply lubricating oil or "WD40" onto the metal bearing occasionally.
