Angels Horn HP-H00501 Quick Start Guide
Installation
Place the turntable platter onto the spindle.
Install the drive belt around the motor pulley and the platter rim.
Manually turn the turntable clockwise and counterclockwise to prevent jamming.
Place the turntable mat onto the platter.
Carefully attach the stylus to the tonearm. Ensure it is properly seated.
Check the tonearm balance. OK: Arrow points to the green zone. NOT OK: Arrow points to the red zone (refer to step 5 diagram).
Carefully adjust the anti-skate dial. OK: Dial is set correctly. NOT OK: Dial is not set correctly (refer to step 6 diagram).
The dial should be set to a value around 1.75g +/- 0.25g, matching the stylus tracking force.
Check the tonearm balance again. OK: Arrow points to the green zone (refer to step 7 diagram). NOT OK: Arrow points to the red zone (refer to step 5 diagram).
Close the turntable lid.
Connect the audio cables to the appropriate output jacks (R+R-, L-L+).
Connections
Connection to Included Speakers: Connect the audio cables from the turntable to the "SPEAKERS" input on the active speakers.
Connection to External Speakers: Connect the audio cables from the turntable to the "PHONO" or "LINE" input of your external amplifier or speakers. Ensure the switch is set to the correct input type (PHONO/LINE).
Connect the DC power adapter to the turntable and then to a power outlet.
For 7-inch records, use the RPM adapter.
Place a record on the turntable. Select the correct speed (33 RPM or 45 RPM) by moving the speed selection switch.
Operation
Lift the tonearm from its rest.
Gently move the tonearm over the record's lead-in groove.
Slowly lower the tonearm onto the record using the cueing lever.
The turntable will begin to spin at the selected speed.
The tonearm will automatically lift at the end of the record.
Adjust the counterweight to set the tracking force. The dial on the counterweight should align with the tonearm's center line.
If there is too little or no sound when playing, please increase the weight of the counterweight by turning it clockwise.
Stop the Turntable
Lift the tonearm from the record using the cueing lever.
Return the tonearm to its rest.
Turn off the power switch.
Ensure the tonearm is secured with the tonearm clip.
Note:
- When the record is played to the end, it will enter the inner closed loop and continue to rotate. Manually raise the tonearm to stop it.
- After power on, the blue LED light flashes to indicate that Bluetooth is searching for devices. A steady light indicates that Bluetooth is paired. If not paired for two minutes, the blue light turns red, which is the power indicator.
