SUNLIKE PRO 30W Installation Manual

01 Introduction

Thank you for purchasing SUNLIKE PRO Urban Lighting Products.

Outdoor solar lighting systems use solar cells which convert sunlight into electricity. Electricity is stored in batteries for use at night. SUNLIKE PRO solar lights are easy to install and virtually maintenance free. Using them won't increase your electric bill.

Important Notes:

• To avoid deep discharge of the battery during storage, please fully recharge your battery every 4 months.
• Ensure the light is installed in an area with sufficient sunlight irradiance, a minimum of 3.5 hours/day of sunshine on average is recommended.
• Select the right operating mode according to local legislation and sunshine conditions.
• Keep the fixture away from shadows.
• Self-cleaning is available when the light fixture has a minimum tilt angle of 15 degrees.

The range of the light module on the lighting fixture is 20-26 feet (6-8 meters). The ideal installation spacing is greater than 16 feet (5 meters). When installing two or more lighting fixtures on one pole, select the desired operating mode before installation, as interference can cause delay or malfunction when using the remote control to change modes after installation.

Precautions when working with solar panels:

When the solar panel is exposed to sunlight, a voltage appears at its output terminals, making it a source of electricity. To avoid a shock hazard, ensure the solar panel is covered with an opaque (dark) material, such as paper or cloth, during installation. Do not make contact with the terminals when the panel is exposed to sunlight or any other light source.

Please save these instructions. Read all instructions carefully before attempting any installation or wiring. Do not open or attempt to repair the product yourself, as it may cause serious damage and void the product warranty. Contact your local distributor for any questions concerning the installation.

02 Battery Notes

• Super Capacitor battery powered SUNLIKE PRO lights are visibly brighter than other outdoor solar lights, and their performance overall is more reliable.
• To charge the battery fully may take 6 to 12 hours.
• The rechargeable battery can work continuously for 10 hours at full power.
• Output will be reduced to 40% when the battery is below 40% of its capacity.
• Battery will stop charging when the ambient temperature is below -58°F or above 140°F.

Battery Status Indicator:

• Slow red light flashing (Every 2.5s) = Working
• Slow red flashing (Every 5s) = Open circuit
• Red light continuously on = Non-working
• Quick red flashing (Every 0.5s) = Charge fault
• Quick red flashing (Every 0.1s) = Over current or Short circuit

Storage:

To avoid over discharge of the battery during storage, please recharge the lighting fixture every 4 months. Use the dedicated charger to charge, and reset the switch when done.

ATTENTION:

Battery cannot be replaced by the user. Please contact SOLTECH for any battery-related questions.

Initial Operation:

After opening the SUNLIKE PRO 30W package, the solar panel is covered, and the indicator is flashing every 5 seconds, signifying an open circuit mode. Once the fixture is taken out of the package and the solar panel is no longer covered, the SUNLIKE PRO 30W will automatically turn on, and the indicator will begin flashing every 2.5 seconds. The light head will then turn on for 1 minute and then shut off again, indicating the fixture is switching from open circuit mode to standard working mode.

Turning Off:

If you wish to shut off the light, you must first cover the solar panel. Then press the off button on the remote. You can also just press the off button to turn off the lights during the night. When the solar panel detects light, the fixture will activate and resume normal operation again.

(IAP) Intelligent Adaptive Program Battery Control Technology:

To extend the off-grid autonomy of the SUNLIKE PRO 30W under shady trees, heavy rain, and thick clouds, our controllers integrate an adaptive smart control feature to actively track battery capacity and adjust light output accordingly. Before integrating this feature, selecting a light output percentage on the remote would yield an accurate percentage of max LED brightness. Now with (IAP), the controller actively monitors the battery and regulates the electrical current to the LEDs. The controller makes light output of the selected percentage on the remote relative to battery capacity rather than max LED output. This smart-control feature can increase our off-grid performance by up to 40%.

03 Installation and Wiring Compliance

Compliance Requirements:

• Installation and wiring must comply with the State and National Electrical Codes.
• The SUNLIKE PRO 30W model is intended for outdoor use only and should not be installed in an unventilated area. It shall be installed in an environment within the operational temperatures defined for the product.
• The average sunshine in the installation area should be above 3.5 hours/day to ensure full function of the lighting fixture. Avoid areas with shades.
• Before installation, if applicable, ensure the light pole and its foundation are solid enough to withstand the lighting fixture(s).
• Before installation, ensure that the battery is fully charged. Install during sunny days if possible.
• Before installation, press the ON/OFF key in the remote control and check whether it shows a red light on the indicator. Cover the panel and check if the light module turns on normally within 1 minute.

After Installation:

The lighting fixture will automatically turn on at night and turn off during daylight.

Important Notes:

• Always orient the solar panel facing the equator (e.g., facing south if in the Northern Hemisphere).
• Always have a tilt angle of at least 15° to avoid dust accumulation (0° = horizontal plane).

Ordering Information Chart:

Example: STLSTCPRO30T33WMGY. This means the customer wants a SUNLIKE PRO 30 watt, 3000K CCT, Type III, Wall Mount installation, with a Gray finish.

Instruction: DO NOT send the sample number directly to sales representatives. Use the information in the chart above to create a model number with the correct series, wattage, temperature, mounting option, and finish for the product you want.

04 Mounting Accessories

A. TRUNNION-Wall Mount

Part Number: A-b. TLSTCP-WM-30W (for SUNLIKE PRO 30W)

B. TRUNNION-Round

Part Number: B-b. TLSTCP-TRR-30W (for SUNLIKE PRO 30W) works with 2.0 inches to 4.7 inches poles.

C. TRUNNION-Square

Part Number: C-b. TLSTCP-TRS-30W (for SUNLIKE PRO 30W) works with 2.0 inches to 4.0 inches poles.

D. SLIP FITTER-Rotative AND STRAIGHT ARM

05 Installation

Trunnion Mount:

• A. On Wall: Diagram shows the light fixture being mounted to a wall using the Trunnion Wall Mount.
• B. On Round Pole: Diagram shows the light fixture being mounted to a round pole using the Trunnion Round Mount.
• C. On Square Pole: Diagram shows the light fixture being mounted to a square pole using the Trunnion Square Mount.

Slip Fitter and Straight Arm:

• D. On Round Tapered Pole-Slip Fitter: Diagram shows the light fixture being mounted to a round tapered pole using a Slip Fitter.
• E. On Round Tapered Pole-Straight Arm: Diagram shows the light fixture being mounted to a round tapered pole using a Straight Arm.

06 Panel Angle

The solar charge in a battery pack won't last forever. The off-grid system relies on stored solar energy for autonomy. Angling your solar panels properly can boost the power intake of your solar lighting system. You want to angle your solar panels at a tilt based on the area's latitude.

Tip: You can increase the tilt 15° in the winter or decrease 15° in the summer. In this way, you can get the maximum sunlight to recharge the battery.

Key: Strong sunlight, Normal sunlight, Less sunlight.

Best Facing Direction of Solar Panel: Worst, OK, Best.

The area will dictate the installation of the fixtures and will sometimes prevent the lights from facing south. However, panels facing West & East won't get as much light as Southern facing panels, but will still collect a good amount of sunlight. A North facing panel also works, but it will take longer to charge than any other direction, meaning the solar charge will be less optimal if installations are facing North.

07 Remote Control Guide

Remote Functions:

• 1. On/Off ?
• 2. Connect/Test ?
• 3. 40%~100% Motion Sensor Mode ?
• 4. 20%~80% Motion Sensor Mode (Default) ?
• 5. Night Owl Mode ?
• 6. Early Bird Mode ?
• 7. 100% Constant Mode ?
• 8. 70% Constant Mode ?
• 9. 40% Constant Mode ?
• 10. Timer Mode Disabled ⏰ ❌
• 11. Timer Mode 4 Hours ⏰ 4h
• 12. Time Mode 8 Hours ⏰ 8h

Function Descriptions:

• 1. On/Off: When off is selected, the light will stop working. The solar panel will not charge the battery, and the battery will not supply electricity to the light.
• 2. Connect/Test: The remote control device can be connected with any lighting fixture. When all cables are connected and the solar panel detects sunlight, the fixture will automatically turn on. To test, press the 'Test' button once; the LED light will turn on to indicate the fixture has been turned on. During the day time, the indicator will slowly flash red, meaning the battery is charging.

First Use: When using the remote for the first time, please remove the plastic piece at the bottom to activate the remote.

Remote Range: The range of the remote control to the indicator is 16ft (Day time) to 33ft (Night time). Because sunlight will impact the signal of the remote control, it is suggested to set up the mode before installing the light.

Mode Details:

• 3. 40%~100% Motion Sensor Mode: Constant 40% brightness (turns on at dusk, turns off at dawn); 100% brightness turns on for 2 minutes when motion is detected.
• 4. 20%~80% Motion Sensor Mode (Default): Constant 20% brightness (turns on at dusk, turns off at dawn); 80% brightness turns on for 2 minutes when motion is detected.
• 5. Night Owl Mode: Changes as natural light decreases/increases (turns on at dusk); 70% brightness for 0.5 hour, 100% brightness for 3.5 hours, 70% brightness for 1 hour, 50% brightness for 1 hour, 20% brightness for 5 hours (turns off at Dawn).
• 6. Early Bird Mode: Changes as natural light decreases/increases with increased brightness near dawn for early risers (turns on at dusk); 70% brightness for 0.5 hour, 100% brightness for 3.5 hours, 70% brightness for 1 hour, 50% brightness for 1 hour, 20% brightness for 4 hours, 100% brightness for 1 hour (turns off at Dawn).
• 7. 100% Constant Mode: 100% brightness from dusk to dawn.
• 8. 70% Constant Mode: 70% brightness from dusk to dawn.
• 9. 40% Constant Mode: 40% brightness from dusk to dawn.
• 10. Timer Mode Disabled: Press this button to turn off Timer Mode; settings revert back to before Timer Mode was last activated.
• 11. Timer Mode 4 Hours: This is an additional mode which can work with any other modes. For example: press this button at any time after you turn on 70% Constant Mode. If the light turns on at 7pm at dusk, it will turn off at 11pm. It will repeat the same schedule hereafter until it is canceled by pressing Timer Mode Disabled.
• 12. Time Mode 8 Hours: This is an additional mode which can work with any other modes. For example: press this button at any time after you turn on 70% Constant Mode. If the light turns on at 7pm at dusk, it will turn off at 3am. It will repeat the same schedule hereafter until it is canceled by pressing Timer Mode Disabled.

Important Note: Dusk and dawn time may vary for different locations and seasons. The sensors in our products will monitor the light levels where it is installed. The time period shown in the charts are examples to help you understand the different lighting modes.

(IAP) Intelligent Adaptive Program Battery Control Technology: To extend the off-grid autonomy of the SUNLIKE PRO 30W under shady trees, heavy rain, and thick clouds, our controllers integrate an adaptive smart control feature to actively track battery capacity and adjust light output accordingly. Before integrating this feature, selecting a light output percentage on the remote would yield an accurate percentage of max LED brightness. Now with (IAP), the controller actively monitors the battery and regulates the electrical current to the LEDs. The controller now applies the selected percentage output on the remote to the battery capacity, rather than the max LED output. This smart-control feature can increase our off-grid performance by up to 40%.

Warranty Information

SUNLIKE PRO products are covered by a 5-year limited warranty. SOLTECH urban light warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 5 years from date of purchase. To obtain warranty service, please contact your local distributor or sales representative for further instruction.

SOLTECH Contact Information:
1460 Park Avenue, Emeryville, CA 94608 USA
Website: www.soltechlighting.com
For publication updates, contact SOLTECH marketing specialists at hello@soltechlighting.com.

Copyright © 2021-2022 SOLTECH LLC. All Rights Reserved.