48" Furniture Style Large Dog Crate

STEP 1

Use tools (1) [M5*45 Screw] and (6) [M4 Screw] to screw the two (F) square tubes on either side of the backing board (I).

STEP 2

Use tools (1) [M5*45 Screw] and (6) [M4 Screw] to screw the iron frame (A) to the backing board (I). Then, use tools (2) [M6*30 Screw] and (6) [M4 Screw] to screw the iron frame (A) to the (F) square tubes and the (E) square tube.

Please pay attention to the hole position in the picture and screw it in vertically.

STEP 3

Use tools (1) [M5*45 Screw] and (6) [M4 Screw] to screw the iron frame (B) to the backing board (I). Then, use tools (2) [M6*30 Screw] and (6) [M4 Screw] to screw the iron frame (B) to the (F) square tubes and the (E) square tube.

STEP 4

Use tools (3) [M6*25 Screw] and (6) [M4 Screw] to screw the bottom board (H) to the bottom (F) square tubes. Use tools (3) [M6*25 Screw] and (6) [M4 Screw] to screw the top board (G) to the top (F) square tubes. Screw (L) [Tube Connector] into the corresponding (F) tube holes.

Please pay attention to the hole position in the picture and screw it in vertically.

STEP 5

Use tools (4) [M6*22 Screw], (5) [M6 Nut], (6) [M4 Screw], and (7) [Wrench] to screw the dog feeding tray (J) to the iron frame (A). Then, use tools (10) [Philips Head Screwdriver] and (12) [M4*20 Screw] to screw (13) [Plastic Parts] onto the bottom board.

You can measure the height of your dog and select the corresponding installation height for the feeding tray:

• Measure your dog from the floor to the highest point of their shoulder blades.
• Match your dog's measurement to the feeder height on the chart.

STEP 6

Take out the left and right iron doors (C) and (D) respectively. Insert the iron door hinges from the top according to the method shown in the figure. Then, use tools (8) [Handheld Lock], (9) [M4*25 Screw], and (10) [Philips Head Screwdriver] to tighten the door handle on the door.

STEP 7

Use tools (10) [Philips Head Screwdriver] and (12) [M4*20 Screw] to screw (11) [U-button] onto the guide holes of the top plate and bottom plate respectively. Then, place the dog bowl (K) into the feeding tray.

Please pay attention to the hole position in the picture and screw it in vertically.

STEP 8

If your dog tends to shake the door, causing the deadbolt to be loose and the door to rattle, you can use the anti-collision sticker (14) [Bumper Stickers]. Stick it on the position shown in the picture. Note that this may increase the difficulty of opening and closing the lock. Please make your choice accordingly.