Make-up Mirror Wireless Charger Power Bank

User Manual

Portable Power Bank

A

Specifications

• Make-up Mirror Wireless Charger Power Bank
• Battery Capacity: 3000mAh (11.1Wh)
• Phone Output Power: 7.5W Max
• Light Power: 3W Max
• Type-C Output/Input: 5V-2A

Mobile Power Product Indication

• 7.5W magnetic charging position
• Power switch
• Mirrors
• Touch on light (adjust the light color gear)
• Fill-in light
• USB-C Input/Output
• Battery level display
• 0%-25% (Indicator light flashes)
• 25%-50%
• 50%-75%
• 75%-100%

Compatible Devices

• For Mobile Phone
• iPhone 15 Series/iPhone 14 Series/iPhone 13 Series/iPhone 12 Series

Please use a magnetic case to charge your phone.

Please Note:

1. Only use certified QC Charging Wall Adapter to charge the device. Do not plug into computer USB port or any other non-certified USB port.
2. Place your Qi-enabled device accurately in the wireless charging area when charging.
3. A QC adapter is required when charging mobile phones can be quickly charged.
4. Make sure to disconnect the device from power when cleaning.
5. It is normal and safe to hear a humming noise when very close to the charger. It means that this wireless charger is adjusting its temperature to achieve a more efficient charging speed.
6. If your device cannot be fully charged, this may be due to high environmental temperature. Please recharge after the temperature is lowered. The charger has temperature control to safeguard your device when charging.

Important Safety Instructions

• Do not store device in high-temperature environment, including heat caused by intense sunlight or other forms of heat.
• Do not place device in fire or other excessively hot environments. Exposure to fire or temperature above 212°F (100°C) may cause explosion.
• Do not use the wireless charger in excess of its output rating. Overloading outputs above rating may result in a risk of fire or injury to persons.
• Do not expose the wireless charger to rain or snow.
• Do not modify, repair, or disassemble the unit. If so, please contact the manufacturer. Switch off the wireless charger when not in use. The wireless charger will automatically switch off when disconnected from its wall charger.

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Material: 128g Copperplate

Finished Product Size: 60*85*mm

CE FC ROHS

Made in China

Shenzhen Yifeng Intelligent Technology Co., Ltd.

Material Name: User Manual (Compliant with RoHS)

Product Name: Multifunctional Wireless Charger

Product Engineer: Zhan Jianfeng

Designer: Jiang Li