LEDBERG LED Light Strip
IKEA Design and Quality
Important Safety Instructions
For indoor use only.
Regularly check the cord, the transformer, and all other parts for damage. If any part is damaged, the product should not be used. Keep these instructions for future use.
CAUTION! The light source of this product is non-changeable light diodes (LED). Do not disassemble the product, as the light diodes can cause damage to the eyes. Do not immerse in water.
Cleaning: Use a damp cloth, never a strong cleaning agent.
WARNING: Deviation from the assembly instructions may result in a risk of fire or electric shock.
CAUTION: To reduce the risk of fire, electric shock, or injury to persons: Use only insulated staples or plastic ties to secure cords. Route and secure cords so that they will not be pinched or damaged when the cabinet is pushed to the wall. Not intended for recessed installation in ceilings or soffits. The low-voltage portable cabinet light may be installed inside or under a kitchen cabinet or other built-in furniture when:
- The low-voltage Class 2 power supply is located outside the cabinet and is not concealed; and
- The line voltage power supply cord is not concealed or run through openings in the cabinet, walls, ceilings, or floors. This requirement does not apply to the wiring between the cabinet light and the power unit. The National Electric Code (NEC) does not permit cords to be concealed where damage to insulation may go unnoticed. To prevent fire danger, do not run cord behind walls, ceilings, soffits, or cabinets where it may be inaccessible for examination. Cords should be visually examined periodically and immediately replaced when any damage is noted.
ATTENTION: CAUTION: Injury to persons and damage to the lamp and/or the mounting surface may result if the lamp is pulled from the surface. To reduce the likelihood of such injury or damage, mount only on a surface that is mechanically sound.
This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions: 1. This device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Product Description and Components
The LEDBERG light strip is a flexible LED lighting solution. The package typically includes:
- 1x LED light strip
- 1x Power cord with connector and dimmer/controller
The light strip can be cut at the designated marks. Ensure the device is unplugged before cutting.
Assembly and Usage
Follow these steps for assembly:
- Connect the power cord to the LED strip.
- Attach the LED strip to the desired surface.
- Connect the power cord to the power adapter.
Dimmer/Controller Functions:
- Pressing the button once (x1) may turn the light on/off or cycle through colors/brightness levels.
- Multiple presses (x2, x3, x4) may activate different modes or settings. Refer to the visual indicators for specific functions.
Important Notes on Plug and Installation
This product has a polarized plug (one blade is wider than the other) to reduce the risk of electric shock. The plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless the plug can be fully inserted. Do not attempt to defeat the safety purpose of the polarized attachment plug. Do not alter the plug.
CAUTION: TO PREVENT ELECTRICAL SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
Do not pull the luminaire from the mounting surface, as this may cause injury or damage. For safety reasons, fix the luminaire to a solid and suitable surface.
