Zennio RemoteBOX ZSYRBOX

Features

• Remote control with Zennio Remote
• Compatibility with ZenVoice through license
• Supports KNX Data Secure
• External 24-29 VDC power supply
• Ethernet connection RJ45 10/100Mbps Base T
• 10 logic functions
• Total data saving on KNX bus failure
• Integrated KNX BCU (TP1-256)
• Dimensions 67 x 90 x 36 mm (2 DIN units)
• DIN rail mounting according to IEC 60715 TH35, with fixing clamp
• Conformity with the CE, RCM directives (marks on the right side)

Figure 1: RemoteBOX

Diagram showing the RemoteBOX with numbered components:

• 1. External Power Supply
• 2. Ethernet connector
• 3. Multifunction reset LED
• 4. Multifunction reset button
• 5. Programming button
• 6. Programming LED
• 7. Synchronization LED
• 8. IP connection LED
• 9. KNX connector
• 10. Without use
• 11. Server connection status LED

Button Descriptions:

• Programming button: Short press to set programming mode. Holding while plugging into the KNX bus enters safe mode. Pressing for 10 seconds in safe mode performs a KNX Secure factory reset.
• Multifunction Reset button: Short press performs a webtools password reset (associated LED flashes yellow).

LED Descriptions:

• Programming LED: Programming mode indicator (red). Blinks red every half second in safe mode. Flashes red during start-up (reset or after KNX bus failure) if not in safe mode.
• Synchronization LED: Shows device is unloaded or desynchronized (red); synchronizing (yellow flashing); synchronized (green).
• IP connection LED: Shows connection to Ethernet with assigned IP address (green) or no connection/unassigned IP address (red).
• Server connection status LED: Shows correct connection with server (green); connection with failures (yellow); no connection (red).

General Specifications

Maximum consumption in the worst-case scenario (KNX Fan-In model).

External Power Supply and Connections

Pairing Instructions

• From Zennio Remote: Select the device in the Zennio Remote APP and enter the pairing password (from the sticker or a customized one).
• From Webserver tools: Access the remote control tab, click on "New pairing", and the pairing code with a QR will appear.
• Pairing through object: A 1-bit object is sent to generate a pairing code request, and a text string is received with the code or an error message if pairing is not possible.

Attaching RemoteBOX to DIN rail:

Diagram illustrating the process of attaching the RemoteBOX to a DIN rail.

Removing RemoteBOX from DIN rail:

Diagram illustrating the process of removing the RemoteBOX from a DIN rail.

Figure 2: Mounting RemoteBOX on DIN rail

Diagram showing the RemoteBOX mounted on a DIN rail.

Safety Instructions and Additional Notes

• Installation must be performed by qualified professionals according to applicable laws and regulations.
• Do not connect mains voltage or any other external voltage to the KNX bus to avoid risks to the system. Ensure adequate insulation between mains/auxiliary voltage and the KNX bus or other accessory wires.
• Keep the device away from water (including condensation) and do not cover it during use.
• The WEEE logo indicates that the device contains electronic parts and must be disposed of according to instructions at https://www.zennio.com/en/legal/weee-regulation.
• This device contains software subject to specific licenses. Details are available at https://zennio.com/licenses.