ROLINE Projector Ceiling Mount (adjust.)
Model: 17.03.1094
Max Load: 3Kgs
Installation Instructions
Caution
- Prior to the installation of this product, the installation instructions must be read and completely understood. Keep these installation instructions in an easily accessible location for future reference.
- The ceiling structure must be capable of supporting at least five times the weight of the projector. If not, the ceiling structure must be reinforced.
- Proper installation procedure by a qualified service technician must be followed, as outlined in these installation instructions. Failure to do so could result in property damage, serious personal injury, or even death.
- Safety measures must be practiced at all times during the assembly of this product. Use proper safety equipment and tools for the assembly procedure to prevent personal injury.
- At least two qualified people should perform the assembly procedure. Personal injury and/or property damage can result from dropping or mishandling the projector.
- This product is intended for indoor use only. Use of this product outdoors could lead to product failure and/or serious personal injury.
Parts List
| Part | Description | Quantity |
|---|---|---|
| A | Ceiling Plate | 1 pc |
| B | Extension Tube (short) | 1 pc |
| C | Extension Tube (long) | 1 pc |
| D | Screws (#14x2" / 1/4"x2") | 4 pcs/each |
| E | Screws (M6×12mm) | 4 pcs |
| F | Wrench | 1 pc |
Assembly Steps
Step 1: Mount to Ceiling
An illustration of the ROLINE Projector Ceiling Mount, showing a central pole with adjustable sections, a ceiling mounting plate at the top, and a tilting/swiveling head at the bottom.
Illustration showing the ceiling plate (A) being attached to a ceiling surface with four screws (D) ?. Arrows ▶️ indicate the direction of screw insertion. [Diagram 1]
Illustration showing the main mount body being inserted into the ceiling plate. A circular locking ring on the ceiling plate is shown being rotated to secure the mount body. [Diagram 2]
Step 2: Secure Ceiling Plate
Illustration showing four screws (D) ? being inserted through the holes of the ceiling plate from underneath, into the ceiling structure. [Diagram 3]
Step 3: Attach Support Arm
Illustration showing the main support arm assembly being connected to the ceiling plate. Screws (D) ? are used to fasten it. [Diagram 4]
Step 4: Assemble Adjustable Pole
Illustration showing the connection of the lower mount head to an extension tube (B). Screws (E) ? are used for fastening. Arrows ▶️ indicate the direction of assembly. [Diagram 5A]
Illustration showing the connection of another extension tube (C) to the assembly from 5A. Screws (E) ? are used for fastening. Arrows ▶️ indicate the direction of assembly. [Diagram 5B]
Illustration showing the complete assembly of the adjustable pole, connecting extension tubes (B and C) to the mount head and ceiling plate adapter. Screws (E) ? are used for securing. The diagram depicts the sequence of joining these parts. [Diagram 5C]
Step 5: Adjust and Lock
Illustration showing the tightening of a locking mechanism on the mount head, labeled 'Tighten the camera'. A circular component is being rotated. [Diagram 6-1]
Illustration showing an adjustment screw being turned, labeled 'adjust forward', indicating adjustment of the projector's angle. [Diagram 6-2]
Illustration showing the use of the wrench (F) ? to tighten a bolt or locking screw, labeled 'Tighten the metal piece for lock', to secure the adjusted angle of the mount head. [Diagram 6-3]
A final view of the assembled mount head, ready to attach a projector. [Diagram 6-4]
