Redmi Note 13 5G Quick Start Guide

Welcome

Thank you for choosing the Redmi Note 13 5G. Press and hold the power button to turn on the device. Follow the on-screen instructions to configure your device.

For more information, please visit our official website: www.mi.com/global/service/userguide

About SIM Card

Please do not insert non-standard SIM cards into the SIM card slot. They may damage the SIM card slot.

WARNING: Do not disassemble this device.

Waste Electrical and Electronic Equipment (WEEE)

Special precautions must be taken to dispose of this product safely. This marking indicates that this product should not be disposed of with other household wastes within the EU. To prevent harm to the environment or human health from uncontrolled waste disposal, please recycle it responsibly to promote the sustainable reuse of material resources.

To safely recycle your device, please use return and collection systems or contact the retailer where the device was originally purchased.

PRECAUTIONS

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

To prevent possible hearing damage, do not listen at high volume levels for long periods.

Additional safety and precautionary information can be found at: www.mi.com/en/certification

Important Safety Information

Read all the safety information below before using your device:

• Using unauthorized cables, power adapters, or batteries may lead to explosion, fire, electric shock, or other hazards, or may damage the device.
• The operating temperature range for this device is 0°C to 40°C. Using this device in environments outside this temperature range may damage the device.
• If your device is equipped with a built-in battery, do not attempt to replace the battery yourself to avoid damaging the battery or device.
• Charge the device only with the included or an authorized cable and power adapter. Use only authorized accessories compatible with your device.
• After charging is complete, disconnect the adapter from both the device and the power outlet. Do not charge the device for more than 12 hours.
• The battery must be recycled or disposed of separately from household waste. Improper handling of the battery may cause fire or explosion. Dispose of or recycle the device, battery, and accessories in accordance with your local regulations.
• Do not disassemble, strike, crush, or incinerate the battery. If the battery appears deformed or damaged, stop using it immediately.
• Do not short-circuit the battery, as this may cause overheating, burns, or other injuries.
• Do not place the battery in a high-temperature environment. Overheating may cause an explosion.
• Do not disassemble, strike, or crush the battery, as this may lead to battery leakage, overheating, or explosion.
• Do not ignite the battery, as this may cause fire or explosion.
• The user should not remove or modify the battery. Battery removal or repair should only be performed by an authorized service center of the manufacturer.
• Keep your device dry.
• Do not attempt to repair the device yourself. If any part of the device is not working properly, contact Mi customer support or take your device to an authorized service center.
• Connect other devices in accordance with their user manuals. Do not connect incompatible devices to this device.
• For AC/DC adapters, the socket-outlet shall be installed near the equipment and shall be easily accessible.

Safety Precautions

Observe all applicable laws and regulations restricting the use of mobile phones in specific situations and environments.

• Do not use your phone in gas stations or in any explosive atmosphere or environment, including refueling areas, below boat decks, fuel or chemical storage or transfer facilities, or areas where the air may contain chemicals or particles such as grain, dust, or metal powder. Observe all posted signs to turn off wireless devices such as your phone or other radio equipment. Turn off your mobile phone or wireless device when in blasting areas or in areas where "two-way radios" or "electronic devices" are required to be shut off to prevent potential hazards.
• Do not use your phone in hospital operating rooms, emergency rooms, or intensive care units. Always comply with all rules and regulations of hospitals and health centers. If you have a medical device, please consult your doctor and the device manufacturer to determine whether your phone can interfere with the operation of the device. To avoid potential pacemaker interference, always maintain a minimum distance of 15 cm between your mobile phone and your pacemaker. This can be achieved by using the phone on the ear opposite the pacemaker and not carrying the phone in a breast pocket. To avoid interference with medical equipment, do not use your phone near hearing aids, ear implants, or other similar devices.
• Observe all aircraft safety regulations and turn off your phone when on board an aircraft, as required.
• When driving, use your phone in accordance with applicable traffic laws and regulations.
• To avoid lightning strike, do not use your phone outdoors during thunderstorms.
• Do not use your phone for calls while charging.
• Do not use your phone in high humidity locations, such as bathrooms. This may cause electric shock, injury, fire, and damage to the charger.

Safety Declaration

Please update your phone's operating system using the built-in software update feature, or visit one of our authorized service centers. Updating the software through other means may damage the device or lead to data loss, security issues, and other risks.

EU Regulations

Declaration of Conformity with RED

Xiaomi Communications Co., Ltd. hereby declares that this GSM/GPRS/EDGE/UMTS/LTE/5G NR digital mobile phone with Bluetooth and Wi-Fi 2312DRAABG is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.mi.com/en/certification

RF Exposure Information (SAR)

This device complies with the Specific Absorption Rate (SAR) limits for the general population/uncontrolled exposure (Localized 10-gram SAR for head and trunk, limit: 2.0 W/kg) as specified in Council Recommendation 1999/519/EC, ICNIRP Guidelines and RED (Directive 2014/53/EC).

During SAR testing, this device was set to transmit at its highest certified power level in all tested frequency bands and placed in positions that simulate RF exposure during use against the head without separation and close to the body with a separation of 5 mm.

SAR compliance for body-worn operation is based on a separation distance of 5 mm between the device and the human body. This device should be worn at least 5 mm from the body to ensure RF exposure level is compliant with or lower than the reported level. When the device is attached close to the body, use a belt clip or holster that does not contain metal components and allows for a separation of at least 5 mm between the device and the body. RF exposure compliance has not been tested or certified with any metal-containing accessory worn on the body, and the use of such an accessory should be avoided. Any accessory used with this device for body-worn operation must keep the device at least 5 mm from the body.

Information on Certification (Highest SAR value)

SAR 10 g limit: 2.0 W/Kg,

SAR value: Head: 0.943 W/Kg, Body: 0.998 W/Kg (5 mm separation).

Legal Information

This device may be used in all EU member states. Observe national and local regulations when the device is used.

This device may only be used indoors when operating in the frequency range 5250 to 5350 MHz in: AT,BE,BG,HR,CY,CZ,DK,EE,FI,FR,DE,EL,HU,IE,IT,LV,LT,LU,MT,NL,PL,PT,RO,SK,SI,ES,SE,UK(NI),IS,LI,NO,CH,TR

Wi-Fi connectivity capabilities (including Wi-Fi frequency bands, Wi-Fi standards, and other features approved in the IEEE 802.11 standard specifications) may vary depending on regional availability and local network support. The feature may be added via wireless update when and where applicable.

Restrictions in the 2.4 GHz band:

Norway: This subsection does not apply to the geographical area within a radius of 20 km from the center of Ny-Ålesund.

Please ensure that the power adapters used comply with applicable national regulations and international and regional safety standards.

Frequency Bands and Power

This mobile phone offers the following frequency bands only in EU countries and maximum radio frequency power:

• WCDMA band 1/8: 25.7 dBm
• LTE band 1/3/7/8/20/28/38/40/41: 25.7 dBm
• 5G NR band n1/n3/n7/n8/n20/n28/n38/n40/n41: 26 dBm, 5G NR band n77/n78: 29 dBm
• Bluetooth: 20 dBm
• Wi-Fi 2.4 GHz band: 20 dBm
• Wi-Fi 5 GHz: 5150 to 5250MHz: 23 dBm, 5250 to 5350 MHz: 20 dBm, 5470 to 5725 MHz: 20 dBm, 5725 to 5850 MHz: 14 dBm
• NFC: 13.56 MHz < 42 dBuA/m at 10 m

5G connectivity is subject to country, operator, and user environment.

FCC Regulations

This mobile phone complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This mobile phone has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Information (SAR)

This device complies with government requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy. The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate, or SAR.

The SAR limit set by the FCC is 1.6 W/Kg. For body-worn operation, this device has been tested and meets the FCC RF exposure guidelines for use with an accessory that contains no metal and is positioned a minimum of 1.0 cm from the body. RF exposure compliance for body-worn accessories containing metal is not tested or certified and the use of such an accessory should be avoided. Any accessory used with this device for body-worn operation must keep the device at least 1.0 cm from the body.

FCC Note

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Shielded cables must be used with this device to ensure compliance with FCC Class B limits.

Electronic Label

This device has an electronic label for certification information. To access it, go to Settings > About phone > Certificates, or open "Settings" and type "Certificates" in the search bar.

Model Information

Model: 2312DRAABG

2312 indicates that this product will be released after December 2023.

Model: MDY-14-EL / MDY-16-EF

For more information about the adapter, please visit our official website: www.mi.com/global/service/userguide

Disclaimer

This quick start guide is published by Xiaomi or its local affiliated company. Improvements and changes to this guide necessitated by typographical errors, inaccuracies of current information, or improvements to programs and/or equipment may be made by Xiaomi at any time and without notice. However, such changes will be included in new online editions of the quick start guide (see details at www.mi.com/global/service/userguide). All illustrations are for illustrative purposes only and may not accurately represent the actual device.

Manufacturer Information

Manufacturer: Xiaomi Communications Co., Ltd

Manufacturer's Postal Address: #019, 9th Floor, Building 6, 33 Xi'erqi Middle Road, Haidian District, Beijing, China, 100085

Brand: Redmi

Model: 2312DRAABG

© Xiaomi Inc. All rights reserved.