Oraimo UltraCleaner Scrubber 2
Welcome Guide
ATTENTION
When using the electric spin scrubber, basic precautions should always be followed, including the following:
- Before the first operation, read this manual carefully and keep it for future reference.
- This product is not a toy. Close supervision is required when this machine is used by or near children. Store out of reach of children.
- To protect against the risk of electric shock, do not put the battery charger in the water or other liquid. Do not charge battery if it is wet or shows signs of corrosion. Do not place or store appliance where it can fall or be pulled into a tub or sink.
- Do not incinerate the battery. It may explode in a fire. A small leakage from the battery cell may occur under extreme usage, charging or temperature conditions. This does not indicate a failure. However, if the outer seal is broken, cracked or damaged and this leakage gets on your skin, please wash it immediately with soap and water or neutralize with mild acid such as lemon juice or vinegar. If the liquid gets into the eyes, flush them immediately with clean water for at least ten minutes. Seek medical attention.
- Do not charge the unit outdoors; store indoors after each outdoor use.
- This appliance can be used by children aged from 8 years, and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
- Do not use the charger in wet or damp conditions. It is intended for indoor use only. Do not use charger near sinks or tubs. Do not immerse it in water.
- Do not allow the cord to hang over the edge of a table or counter or touch hot surfaces. The charger should be placed away from sinks or hot surfaces.
- For the best results, do not charge a battery when the air temperature is below 40°F (5°C) or above 105°F (40°C).
- Unplug the charger when not in use or before cleaning.
- Do not abuse the cord. Do not carry the charger by the cord or yank the cord to disconnect. Grasp the charger plug and pull to disconnect. Keep charger cord away from heat and sharp edges.
- Do not operate in the presence of explosives and/or other flammable fumes or liquids.
- If abnormal noise, smell, smoke or any other failure or breakage is found during the operation, turn off the switch and unplug it. Then, contact the customer support team immediately. Do not repair by yourself.
- Do not store or use it close to high temperatures.
- Always keep proper eye protection when using the scrubber with irritating substances. Rubber gloves are also recommended.
- Please make sure to turn off the machine first when changing accessories.
- Please make sure to charge the machine when in the OFF position.
- This appliance is only for household use, not for commercial or industrial use.
- WARNING: For the purposes of recharging the battery, only use the detachable supply unit provided with this appliance. The plug must be removed from the socket-outlet before cleaning or maintaining the appliance.
- Always store the unit indoors.
- Keep hair, loose clothing, and all parts of the body away from moving parts.
- Do not use the appliance when charging.
- Do not submerge the handle in water or other liquid.
- Use only as described in this manual. Use only recommended parts.
- Only use attachments recommended or sold by the manufacturer.
- To disconnect, turn all controls to the OFF ("O") position, then remove the plug from outlet.
- Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions or is dropped or damaged in any manner.
PACKAGE CONTENTS
The package includes the following items:
- Drying Net x 1
- Type-C Charging Cable x 1
- Welcome Guide x 1
- Spin Scrubber x 1
- Corner Brush x 1
- Pointed Brush x 1
- Large Flat Brush x 1
- Dome Brush x 1
PRODUCT OVERVIEW
The Oraimo UltraCleaner Scrubber 2 consists of the following main components:
- 1. Main Handle: The primary body of the scrubber.
- 2. Length Adjust Button: Used to extend or retract the handle.
- 3. Extension Handle: Provides adjustable length for comfortable use.
- 4. Release Button: Used for detaching or attaching components.
- 5. Power Button/Spin Speed Button: Controls the power and adjusts the spin speed.
- 6. Scrubber Head: The part that attaches to the brushes and performs the scrubbing action.
- 7. Angle Adjustment Button: Allows adjustment of the scrubber head's angle.
- 8. Charging Port: Located on the back of the machine for charging the battery.
SPECIFICATIONS
Property | Value |
---|---|
Size | 1170*105*65mm |
Input | 5.0V 1A |
Battery Capacity | 3.7V 2500 mAh 9.25Wh |
Material | ABS |
PRODUCT OPERATION INSTRUCTIONS
WARNING:
- Always use rubber gloves and keep proper eye protection to avoid contact from splashing of soaps or detergents on skin and/or eyes while brush head is spinning and when brushes are removed or attached.
- After using the scrubber, turn the unit off while the brush is still in contact with the surface to avoid getting splashed with soaps or detergents.
- Always test on a small, inconspicuous area before using on a larger area. Always follow surface manufacturer's guidelines for cleaning and maintenance.
- Do not expose the unit to excessive water. If the scrubber accidentally becomes submerged in water or water gets into the "Charging Port", shake out liquid and air dry the machine for 24 hours at least.
- Choose the proper brush attachment and attach it to the scrubber as directed in "Assembly Instructions."
- Wet the intended area and apply the desired cleaning product.
- Press and hold the angle adjustment button backward to adjust the brush head to the right angle. Place the tip of the brush on the surface to be cleaned.
- Press the power button to switch on the machine, then adjust the speed by pressing the speed button.
- When done, press the power button to turn off.
CHARGING INSTRUCTIONS
To charge the Oraimo UltraCleaner Scrubber 2:
The charging process involves connecting the provided Type-C cable to the charging port on the machine and a power source. The indicator light on the power button shows the charging status:
- Charging: Steady red light.
- Working (High speed): Steady blue light (2 LED notifications).
- Working (Low speed): Steady blue light (1 LED notification).
- Low battery: Slow flashing red light.
- Fully charged: Steady blue light.
- Motor blocking: Fast flashing red light.
*In order to extend the battery life, please avoid consecutive charging exceeding 12 hours. It is not necessary to wait until battery power is fully depleted before recharging.
- Make sure to turn off the machine before charging.
- Open the "Charging Port Cover" located on the back of the machine.
- Insert the cable end of the charger into the "Charging Port."
- Plug the "Charger" into a wall outlet. The power button indicator light will turn to RED to show the machine is charging.
- The Red light turns to Blue after the machine is fully charged. The Blue light will remain lit when the battery is completely charged.
- When done, close the "Charging Port Cover".
CLEANING & MAINTENANCE
- Use a wet, non-abrasive cloth to clean the scrubber. If needed, use a mild detergent. Then place it in a dry environment to allow it to dry thoroughly.
- Note:
- Do NOT immerse or run under water.
- Do NOT clean with alcohol or petrol.
- Rinse brush attachments under water and clean thoroughly after use. Then place them in a dry environment to air dry them thoroughly.
Troubleshooting Guide
Problem | Remedy |
---|---|
The charging indicator doesn't light up when charging. |
|
The charging indicator doesn't turn blue after charging for over 5 hours. |
|
The brush head stops spinning while working. |
|
The charging indicator turns blue (representing full charge) but the brush head does not spin after it is turned on. |
|
The brush head spins less than 90 minutes. | Each user will apply different downforce during use. If you keep pressing the brush head hard, the working time will be less than 90 minutes. In order to prolong the use time, please do not press the brush head too hard, as frequent pressing will break the brush head. |
WARRANTY CERTIFICATE
This product is covered by a guarantee from the date of purchase. The warranty is valid only when the warranty card is properly completed.
Warranty is limited to the core product. Accessories included in the package are not covered.
Please contact us if you have a question or experience a problem with the product; we promise to give you a satisfied solution within 24 hours.
365 DAYS WARRANTY
Made in China
Scan to Visit Our Website: us.oraimo.com
Contact us: contact@oraimo.com
Keep Exploring
For more information and support, please visit our website or contact us.
Website: us.oraimo.com
Email: contact@oraimo.com