Silonn Portable Automatic Ice Maker
Instruction Manual
Model: SLIM01G1
Version: V1.0 (A)
Introduction
Thank you for choosing this Silonn product! At Silonn, we strive to provide you with the best quality products and services in the industry. Should you have any issues, please don't hesitate to contact us.
Important Safety Information
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE.
⚠️ WARNING
To reduce the risk of fire, explosion, electrical shock, or injury when using the unit, follow these basic safety precautions:
- Do not under any circumstances, alter or move the third (ground) prong from the power cord. For personal safety, the unit must be properly grounded.
- Do not exceed the power outlet limit. It is recommended that the unit is connected to its own circuit. Use only a 115V, 60 HZ standard electrical supply that is properly grounded following the National Electric Code and local codes and ordinances.
- Due to potential safety hazards under certain conditions, we strongly advise against the use of an extension cord. However, if you must use an extension cord, it is absolutely necessary that it is a UL-listed, 3-wire ground type appliance extension cord having a grounding type plug and that the electrical rating of the cord is 2 Amperes (minimum) and 115 Volts.
- The unit must be properly installed and located following the installation instructions before it is used. The unit is for indoor household use only. Do not use outdoors.
- Do not store or use flammable vapors or liquids near the unit.
- Do not allow children to climb, stand, or hang on the unit. Serious injury may occur.
- Do not use water that is micro-biologically unsafe or of unknown quality.
- Do not place the power cord in such a way it could be pulled on by children or cause a tripping hazard.
- Do not place the power cord in such a way that it is in contact with hot surfaces.
- Do not operate if any component, including the cord or plug, is damaged.
- Unplug the unit before cleaning by hand and when not in use.
- Do not immerse any part of the unit in water.
- Do not plug or unplug the unit with wet hands.
- Do not attempt to disassemble, repair, modify, or replace any part of the unit.
❗ CAUTION
To reduce the risk of injury when using the unit, follow these basic safety precautions:
- Do not remove any safety, warning, or product information labels from the unit.
- Closely watch children who are near the unit when it is making ice.
⚠️ WARNING
FIRE OR EXPLOSION HAZARD Flammable Refrigerant
This unit contains an isobutane refrigerant, also known as R600a, a natural gas with high environmental compatibility. However, it is also combustible. Adhere to the warnings below to reduce the risk of injury or property damage.
- When handling, installing and operating the unit, care should be taken to avoid damage to the refrigerant tubing.
- Disposal of the unit under Federal and Local Regulations. Contact your local authorities for the environmentally safe disposal of your refrigerator.
- Keep ventilation openings in the unit enclosures or the built-in structure clear of obstruction.
- Do not place the unit near heat sources such as an oven.
- Ensure a minimum of three inches of clearance around the side and back walls of the unit for proper air circulation.
- Do not place the unit in direct sunlight.
Product Introduction
This section describes the components of the Silonn Portable Automatic Ice Maker.
Key Components:
- 1. Ice Shovel: Used to scoop ice.
- 2. Ice Full Sensor: Detects when the ice basket is full.
- 3. Ice Basket: Holds the ice produced.
- 4. Large Viewing Window: Allows observation of the ice-making process.
- 5. Air Exhaust Fan: Dissipates heat from the unit.
- 6. Drain Plug: Located at the bottom, used for draining water.
- 7. Maximum Water Fill Line: Indicates the maximum level for water in the reservoir. (This line is visible after removing the ice basket).
- 8. Control Panel: Located on the top, used for operating the unit.
- 9. Ice Scoop: A smaller scoop for serving ice.
Control Panel Introduction
The control panel allows you to manage the ice maker's functions.
| Indicator/Button | Function |
|---|---|
| 1. ADD WATER | The indicator light turns red when the water reservoir lacks water. |
| 2. ICE FULL | The indicator light turns red when the ice basket is full. |
| 3. S | The indicator light turns green when small ice mode is selected. |
| 4. L | The indicator light turns green when large ice mode is selected. |
| 5. ON/OFF CLEAN | Short press to turn on the ice maker; the "POWER" indicator light turns green. Short press to turn off the ice maker; the "POWER" indicator flashes green. When the ice maker is in "stand by" mode, long-press the "ON/OFF/CLEAN" button for 5 seconds to initiate self-cleaning mode. The indicator lights of "S" and "L" will flash green consecutively. |
| 6. SELECT | Confirms the selection of large ice mode or small ice mode. |
Using Your Ice Maker
Before First Use:
- Unpack the unit and check that all accessories, including the ice basket and ice scoop, are included. Contact Silonn if any accessories are missed.
- Ensure the unit is level and placed on a stable table or platform to avoid malfunction.
- Only use drinking water.
- Do not fill the water reservoir with hot water, as this may damage the unit. It is best to fill the water reservoir with water of room temperature or lower.
- Do not use the unit in a very cold environment (lower than 41°F/5°C).
- Clean the unit by following the "CLEANING AND MAINTENANCE" procedure before operating.
Cleaning And Maintenance
To keep your ice tasting fresh and the unit looking great, cleaning once per week is recommended.
- Remove the ice basket.
- Clean the unit interior with a soft cloth soaked with warm water and vinegar, then rinse with clean water and drain all the water.
- Clean the exterior of the unit with a soft damp cloth. Use a mild dishwashing soap, if necessary.
Note:
- Do not use organic solvents, boiled water, strong detergents, strong acids, or strong alkalis for cleaning.
- Please empty the water reservoir and dry it for storage if the unit is not used for a long time.
- When the unit is not to be used for a long duration, drain the water completely and dry the interior.
- Store in a well-ventilated area.
Product Specifications
| Feature | Specification |
|---|---|
| Model | SLIM01R/SLIM01G1 |
| Voltage/Frequency | 115V/60Hz |
| Ice-making Current | 1.7A |
| Ice-harvest Current | 2.0A |
| Working Power | ≤160W |
| Water Reservoir | 2L (0.53gal) |
| Ice Basket Capacity | 1.32 lbs (0.6 Kg) |
| Ice Making Rate | 26 lbs per day |
| Ice Shape | Bullet |
| Ice Size | Small or Large |
| Material | ABS, PP |
Troubleshooting
| PROBLEM | POSSIBLE CAUSES | SOLUTION |
|---|---|---|
| "ADD WATER" indicator turns on. | Lack of Water. | Stop the ice making cycle, fill water, and press "ON/OFF/CLEAN" key again to restart the ice maker. |
| "ICE FULL" indicator turns on. | Ice basket is full. Infrared light sensor does not work. | 1. Remove the ice from the basket. 2. Contact Silonn for assistance. |
| Ice making cycle is normal but no ice is produced. | 1. Making ice takes too much time. 2. The water temperature is too low. | The room temperature should be 50°F –105°F, water temperature should be 40°F -90°F. |
Contact Information
Thank you again for choosing this Silonn product!
All of us at Silonn do appreciate your product purchase. We hope that you are as happy with the unit as we are with designing and manufacturing it for you. We strive to provide you with the best quality products and services in the industry. If you have any questions, please don't hesitate to contact us.
Technical Support:
877-546-8603 Mon-Fri 8am - 8pm (CST)
Other Info:
support@silonnus.com
